Beper P206VEN160 Manual Del Usuario página 11

Multidirectional Fan Instructions
Note: It is normal to hear an audible click while adjusting the tilting angle
Important: do not tilt the fan head by force for the potential damage.
Important: make sure to turn swing mode off before adjusting tilt of fan head.
Press / button once to switch on the fan; the appliance starts running, at low speed.
To choose fan speed, press /
tors on the control panel turn on, indicating the selected speed.
Press / 4 times to switch off the appliance.
Press to activate swing function. Press again to stop
Press to activate timer. Time is set half hour by half hour, from 0.5hr to 7.5hrs. LED indicator lights on control
panel will display the corresponding set time. The fan will stop automatically after the set time has expired.
Remote control
The remote control includes one CR2025 battery. Battery comes pre-installed.
Pull the plastic insulation film out from the backside of the remote control before first use.
The remote control functions are the same as the control panel on the fan. Follow the same instructions above
to operate the fan remotely.
Note: The remote control must be pointed towards the receiver on the fan in order to work.
Maintenance and storage
Always unplug the unit before cleaning.
To keep the fan clean, the outer shell may be cleaned with a soft, damp cloth. You may use a mild detergent if
necessary. After cleaning, dry the unit with a soft cloth.
Warning: do not let water or any other liquid enter the fan.
Do not use alcohol, abrasive powders, or rough brusher to clean the fan. This may cause damage or deteriora-
tion to the surface of the fan.
Do not immerse the circulator in water.
Wait until the unit is completely dry before use.
Store the fan in a cool, dry location when not in use.
Technical data
Power: 45W
Input: 220-240V~ 50Hz
For any improvement reasons, beper reserves the right to modify or improve the product without any
notice.
The European directive 2011/65/EU on Waste Electrical and Electronic Equipment (WEEE), requires
that old household electrical appliances must not be disposed of in the normal unsorted municipal
waste stream. Old appliances must be collected separately in order to optimize the recovery and
recycling of the materials they contain, and reduce the impact on human health and the environment.
The crossed out "wheeled bin" symbol on the product reminds you of your obligation, that when you
dispose of the appliance, it must be separately collected.
again (twice, for medium speed; three times, for high speed). The LED indica-
10
11 / 58