Publicidad
Idiomas disponibles
Idiomas disponibles
Auger Control
Refer to the Assembly section for instructions on adjusting the auger control cable.
Skid Shoes
Refer to the Assembly section for instructions on adjusting the skid shoes.
Belt Replacement
Auger Belt
To remove and replace your snow thrower's auger belt, proceed as follows:
1.
To prevent spillage, remove all fuel from tank by running engine until it
stops.
2.
Remove the plastic belt cover on the front of the engine by removing the two
self-tapping screws. See Figure 27.
3.
Loosen and remove the two bolts and flat washers securing the belt guide.
See Figure 28 . Remove belt guide.
4.
Roll the auger belt off the engine pulley. See Figure 29.
5.
Carefully pivot the snow thrower up and forward so that it rests on the auger
housing.
SERVICE AND MAINTENANCE
Figure 29
22
Figure 27
Figure 28
Publicidad
