Publicidad
Idiomas disponibles
Idiomas disponibles
EN
5. TECHNICAL SPECIFICATIONS.
Lithium Ion (Li-Ion) Battery
Charger
Adjustable speed, without load (gear I):
Adjustable speed, without load (gear II):
Rod connection:
Rod mixing disc diameter:
Mixer Weight (without paddle):
Maximum mixing volume:
Insulation class:
Sound pressure level LpA :
Sound power level LwA :
Vibration level in the handles:
WARNING: Always use ear protection when sound pressure (LpA) is greater than 85 dB(A).
6. START-UP AND OPERATION.
•
Assemble the rod (9) and screw it firmly to the mixer with the help of two hexagonal keys.
•
Select work gear (10).
•
Check the battery charge status by pressing the button next to the row of leds (11).
•
If necessary, plug the charger into the mains and place the battery on it to start charging (12),
remove it when charging is complete (13).
•
Install the battery by sliding it over the mixer head until it stops (14).
•
To start the boot, you must press the lock button and the start button (15) together. Once the
march has started, you can release the lock button and adjust the speed by pressing the button.
•
At the end of the work, remove the battery by pressing the "press" button and sliding it towards it
(16).
WARNING:
If the machine stops while carrying out the work, it is because the overload protection is
activated. The engine is too hot! Run the machine, with no load, at slow speed until it has cooled down.
7. MAINTENANCE.
•
Remove the battery before performing maintenance or repair on the machine.
•
Keep the vents on the machine clean to prevent overheating of the motor.
•
Regularly clean the machine with a soft cloth, preferably after each use. If there is embedded dirt,
use a cloth moistened with soapy water.
•
Never use solvents such as gasoline, alcohol, etc., as they can damage the plastic parts.
•
The machine must be stored in a clean and dry place, together with the battery decoupled, at an
ambient temperature between 10ºC and 30ºC.
•
Regularly check the state of charge of the battery, if the performance decreases, recharge it.
•
The motor of this machine does not have brushes.
CE-MB18V Mixer + Charger + Battery
18V. DC. / 4000mAh.
1~230V. – 50Hz. / 75W.
0-420 rpm.
0-710 rpm.
Threaded. M14
90 Liters. (according to product density)
II – IPX0 (charger does not require ground connection).
81dB(A) kpA =3dB
92dB(A) kwA =3dB
4.57m/s² k=1.5m/s²
22
120mm.
5.0 kg
Publicidad
