Publicidad
Idiomas disponibles
Idiomas disponibles
2
2
ENGLISH
Your baby monitor
SBC SC465
Philips is dedicated to producing caring, reliable products that new moms
and dads really need. Products whose reliability and operating quality bring
reassurance. You can trust this Philips baby monitor to provide round-the-
clock support by ensuring you can always hear your baby clearly, no matter
where you are in the house.
A
Product illustration on
Baby unit
inside flap:
1
night light
2
DC power supply socket
3
power button
4
power light
5
channel selection switch
6
microphone
7
AC power adapter
8
microphone sensitivity control
9
battery compartment cover
Important information
Please read this guide carefully before using the baby monitor, and keep it
for future reference. This baby monitor is intended as an aid. It is not a
substitute for responsible and proper adult supervision and should not be
used as such.
•
Make sure the Baby unit and adapter cable are always out of reach of the
baby, at least one metre away.
•
Never place the Baby unit inside the baby's bed or playpen!
•
Never cover the baby monitor (with a towel, blanket, etc.).
•
Clean the baby monitor with a damp cloth.
•
Never use the baby monitor near water.
IFU465.p65
2-3
B
Parent unit
10
sound-level lights
11
system check light
12
charging base
13
AC power adapter
14
power light
15
volume control - on/off switch
16
channel selection switch
17
loudspeaker
18
charging light
19
battery compartment cover
20
DC power supply socket
21
system check alarm switch
Getting your baby monitor ready
1
Position the Baby unit at least one metre away from your baby.
Never place the baby unit inside the baby's bed or playpen.
2
Set channel selection switches to the same channel on both units.
3
Connect the power adapter to Baby unit socket.
4
Plug the power adapter into mains supply.
5
Move away from the Baby unit with the Parent unit.
If units are positioned too close to each other then a high-pitched noise
can be heard.
6
Connect the second power adapter to the Parent unit's charging base
DC 9V
socket.
7
Plug the second power adapter into a mains supply.
8
LEVEL
Place the Parent unit inside its charging base.
> The red charging light lights.
SYSTEM CHECK
9
Leave the Parent unit in charging base for at least 14 hours to fully
charge the batteries.
CHARGE
When batteries are fully charged, the Parent unit can be used cordlessly for
up to 12 hours.
10
Place the Parent unit inside the charging base when power light on the
Parent unit flashes red (an indication that batteries are low).
16/01/2002, 10:22
ENGLISH
3
Publicidad
