ErgoAV ERDS1-01G Manual De Instrucciones página 10

Using the Control Panel
Sedentary Reminder Key
(Left Key)
NOTE: If you don't understand the introduction of the standing desk control-
ler's functions, you can scan the QR code to download the APP. The APP
can also control the standing desk, giving you a smarter experience. Before
using this app on Samsung phones, you need to turn off the built-in Bixby.
• Low-Power Function
If there is no operation for 10 seconds, it will enter low-power mode, and the hand controller
will display
• Memory Key Function
There are two presets for the memory function. One for heights greater than 35.5" and one
for lower than 35.5". After setting the memory function, double push/pull on the control panel
will adjust the table to either memory height 1 or 2.
Method of setting: Press the M button located on the right-hand side of the control panel,
and - - - will appear. When the desk is above 35.5 inches, press and hold for M button
- - 1
1 second,
the desk is below or equal to 35.5 inches, press and hold for 1 second,
on the screen and the current position will be saved.
• Sedentary Reminder Function
After setting the sedentary reminder time, press the button on the left side of the control
panel to turn on or off the sedentary reminder function. The sedentary reminder function will
not be timed when the desk height is above 39.3 inches. The sedentary reminder function will
be timed when the desk height is 39.3 inches or below. After the sedentary time ends, the
interface alternately displays
to raise the desk to your desired height. The sedentary reminder function can also be set on
the APP.
Method of setting: Press and hold the M key for 5 seconds. After
menu. Toggle the control panel up or down to locate sedentary reminder function. After locat-
ing the sedentary reminder interface with
submenu. Toggle the control panel up or down to set the sedentary reminder time. Once
confirming the sedentary reminder time, a confirmation icon
before turning off the screen and going to sleep.
will appear on the screen and the current position will be saved. When
and
Controller
at 1.5-second intervals. Prompting you
, press the M key to enter the corresponding
10
M Key
(Right Key)
will appear
- - 2
appears, enter the main
will be displayed.