Publicidad
Idiomas disponibles
Idiomas disponibles
attaching side Discharge Cover
your mower is shipped as a mulcher. to convert to side discharge,
make sure grass catcher is off of the unit and rear discharge door is
closed.
1.
On the side of the mower, lift the mulching cover. see Figure 7.
2.
slide two hooks of side discharge cover under hinge pin on
mulching cover assembly. Lower mulching cover. Do not remove
side mulching cover at any time, even when you are not mulching.
aDjUsTmenTs
Cutting Height
there is a cutting height adjustment lever located above the front and
rear right wheel.
1.
Pull the height adjustment lever towards wheel (unit will tend to
fall when lever is moved outward).
2.
Move lever to desired position for a change in cutting height. see
Figure 8.
3.
Release lever towards deck.
IMPORTANT: all wheels must be placed in the same position. For
rough or uneven lawns, move each height adjustment lever to a higher
position. this will prevent you from cutting the grass too close to the
ground.
Handle pitch
For convenience of operation, you may adjust the pitch of the handle
as follows:
1.
Remove wing nuts and carriage bolts from handle. see Figure 9.
2.
Position the handle in one of the three positions that is most
comfortable. see Figure 9 inset.
3.
secure into position with wing nuts and carriage bolts removed
earlier.
Figure 9
ASSEMBLY
Side Discharge
Cover
Higher
1
12
Side Mulching
Cover
Figure 7
2
Lower
3
Higher
1
Figure 8
1
2
2
Lower
3
Publicidad
