Adler europe AD 2252 Manual De Instrucciones página 5

immediately remove the power plug or power adaptor from the socket. If the device is
powered, do not put hands in the water. Have the device checked by the qualified
electrician before using it again.
18. Do not touch the device or power adaptor with wet hands.
19. The device has to be turned off after every use.
20. Do not leave the unit on to the wall outlet or power supply unit unattended.
21. The device is not designed to work with external schedulers or separate remote control
system
22. Keep the device out of the reach of children. Using the devices by children must be
supervised by adults.
23. The power cord should not touch hot parts of the device and should not be located near
other heat sources.
24. Do not wrap electric cable around the device.
25. Do not use a product in the bath.
26. Do not remove dust or foreign bodies from the inside of the device using sharp objects.
27. Do not use outdoors or where aerosols are being used or where oxygen is being
administered.
28. Do not cover the product, it might cause the accumulation of heat in its interior and it
may cause damage or fire.
29. Hairsprays contain flammable materials. Do not apply them while using the device.
30. Do not use the device on people who are sleeping.
31. The device can be supplied only with the voltage specified on the housing.
32. During operation, do not place the device on wet surfaces or clothes.
33. After using the machine, switch it off, remove each plug the power cord from the wall
outlet and wait before putting it to cool down.
34. Always before applying pieces of equipment on the device, make sure they are dry
outside and inside.
35. Do not obstruct in any way the inlet and the air outlet, eg .:by hair.
36. Do not direct the hot air flow on the power cord
37. Do not direct hot air toward eyes or other sensitive areas..
PRODUCT DESCRIPTION (FIG. 1)
1. - handle
3. - wall base
USING THE DEVICE
1. Remove hair dryer form wall base (3).
2. Set desired speed/temperate by switch (2):
0 - off 1 - low speed, hot air
3. To turn the unit OFF, slide the switch on the hair dryer to the OFF position, or place hair dryer into the base (3), this will automatically
turn the hair dryer off.
INSTALLATION INSTRUCTION
Before mounting on the wall, make sure there are no hidden electrical circuits or pipes in the mounting location. Tool needed: screwdriver,
hammer and electric drill.
Included with hair dryer: 1 plastic wall base, 3 long screws and 3 expansion bolts for mounting the base, 1 metal wall-mounted plate, 1
small screw for securing the base to the metal plate.
Remove all above elements from packing.
Place the metal plate (a) on the wall where it is going to be mounted.
1. As it is natural for coiled electrical cords to "Relax" with use. It is important to mount dryer at a height location that will accommodate
several inches of extra cord length over time.
2. Hold wall metal plate (a), with two tabs on to, flush against the wall. Use wall metal plate (a) as a template to mark the location with
pencil.
3. Remove the metal plate (a) and drill holes at the markings through the plaster wall with 6 mm or 1/4" drill bit, drill approximately 32 mm
2. - speed / temperature adjustment switch
4. - inlet cover grill
2 - high speed, very hot air
5