Publicidad
6.
Remove the belt as follows. Refer to Figure 27.
A. Loosen and remove the shoulder screw which acts as a belt
keeper.
B. Unhook the auger brake bracket spring from the frame.
7.
Remove the belt from around the auger pulley, and slip the belt
between the support bracket and the auger pulley. See Figure 28.
8.
Reassemble auger belt by following instructions in reverse order.
9.
Perform the Auger Control test outlined in the Assembly section
of this manual.
NOTE: Do NOT forget to reinstall the shoulder screw and reconnect
the spring to the frame after installing a replacement auger belt.
Drive Belt
To remove and replace your snow thrower's drive belt, proceed as
follows:
1.
To prevent spillage, remove all fuel from tank by running engine
until it stops.
2.
Remove the plastic belt cover on the front of the engine by remov-
ing the two self-tapping screws. See Figure 24 on previous page.
3.
Remove the belt as follows. Refer to Figure 29.
A. Roll the auger belt off the engine pulley.
B. Use a wrench to pivot the idler pulley toward the right.
C. Lift the drive belt off engine pulley.
SERVICE AND MAINTENANCE
A
C
B
21
B
Figure 27
Figure 28
A
Figure 29
Publicidad
