Publicidad
IMPORTANT NOTE
Proper inflation of the airbed.
The ambient temperatures of air have an effect on the airbed internal pressure. At low
ambient temperature the air will contract within the airbed and the airbed will feel softer:
add air as necessary. At high ambient temperature the air within the airbed will expand
significantly and the airbed will become hard and may burst: release air to avoid damage
to the airbed or to soften the feel. do not expose the airbed to extreme temperatures
(hot or cold). Stretching is a natural characteristic of new vinyl. During initial use, the
airbed may become soft and require additional inflation to maintain desired firmness. This
is normal for the first few days of use. Dimensions shown are approximate and will vary
due to the vinyl temperature and the air temperature.
In no event shall Intex, their authorized agents or employees be liable for damages
(such as pin holes) to the airbed caused by negligence, ordinary wear and tear,
abuse and carelessness, or external forces.
dEFlATION
1. Plug in the AC line cord into an AC electrical outlet. See Fig (1).
2. Slide the switch right to the deflation mark (
3. When the airbed is completely deflated, begin rolling the airbed from the foot of
the airbed towards the head of the airbed where the pump is located. See Fig (7).
4. When all air is removed from the airbed, slide the switch left to the Off mark (
See Fig (3).
5. Disconnect the AC line cord from the wall socket, place it inside the cord compartment.
SAVE THESE INSTRUCTIONS
(150IO) AP620C ELECTRIC PUMP ENGLISH 4.875" X 7.25" 05/06/2021
FIg (6)
Page 4
). See Fig (6).
FIg (7)
150
English
IO
).
Publicidad
