Makita DPJ180ZJ Manual De Instrucciones página 6

ENGLISH
(Original instructions)
1 Button
2 Red indicator
3 Battery cartridge
4 Indicator lamps
5 Check button
6 Star marking
7 Indication lamp
8 Pointer
9 Stopper
10 Adjusting screw
11 Rubber spike
12 Lock lever
13 Angle guide
14 Knob
SPECIFICATIONS
Model
Type of blade
Max. grooving depth
No load speed (min
Overall length
Net weight
Rated voltage
• Due to our continuing program of research and devel-
opment, the specifications herein are subject to change
without notice.
• Specifications and battery cartridge may differ from
country to country.
• Weight, with battery cartridge, according to EPTA-Pro-
cedure 01/2003
Intended use
The tool is intended for cutting crescent shaped slots for
the placement of flat wooden dowels or biscuit by a
plunging action.
General Power Tool Safety Warnings
WARNING Read all safety warnings and all
instructions. Failure to follow the warnings and
instructions may result in electric shock, fire and/or
serious injury.
Save all warnings and instructions for future refer-
ence.
CORDLESS PLATE JOINER SAFETY
WARNINGS
1. Blades must be rated for at least the speed
marked on the tool. Blades running over rated
speed can fly apart and cause injury.
2. Always use the guard. The guard protects the
operator from broken blade fragments and uninten-
tional contact with the blade.
3. Use only the blades specified for this tool.
6
Explanation of general view
15 Scale
16 Tighten
17 Loosen
18 Down
19 Up
20 Center of blade thickness
21 Fence
22 Angle scale
23 Blade cover
24 Set plate
25 Thickness of set plate
26 Slide switch
27 Lock nut
28 Plate joiner blade
–1
)
ENE013-1
GEA010-1
GEB093-1
DPJ140
Plate Joiner
20 mm
6,500
351 mm
3.0 kg
D.C. 14.4 V
4. Never operate the tool with the blade locked in
exposed position or without the blade cover
secured properly in place.
5. Make sure that the blade slides smoothly before
operation.
6. Check the blades carefully for cracks or damage
before operation. Replace cracked or damaged
blades immediately.
7. Make sure that the flange fits in the arbor hole
when installing the blade.
8. Inspect for and remove all nails or foreign matter
from the workpieces before operation.
9. Always place the workpieces on a stable work-
bench.
10. Secure the workpieces firmly with clamp or vise.
11. NEVER wear gloves during operation.
12. Hold the tool firmly with both hands.
13. Keep your hands and body away from the groov-
ing area.
14. Run the tool for a while without the blade point-
ing toward anybody. Watch for vibration or wob-
bling that could indicate poor installation or a
poorly balanced blade.
15. Never reach your hands underneath the work-
pieces while the blade is rotating.
16. Do not leave the tool running unattended.
17. Always be sure that the tool is switched off and
the battery cartridge is removed before making
any adjustments or replacing the blade.
18. Some material contains chemicals which may be
toxic. Take caution to prevent dust inhalation
and skin contact. Follow material supplier safety
data.
19. Do not use blunt or damaged blades.
29 Inner flange
30 Clamp screw
31 Shaft lock
32 Dust bag
33 Fastener
34 Dust nozzle
35 Exhaust vent
36 Inhalation vent
37 Limit mark
38 Holder cap cover
39 Screwdriver
40 Brush holder cap
DPJ180
D.C. 18 V