Publicidad
Idiomas disponibles
Idiomas disponibles
Assembly Instructions
1. Carefully remove the rollator components from the shipping carton. Refer to diagram (Figure 1) as
needed.
2. Examine all parts for shipping damage. DO NOT use the rollator if there is apparent damage or if any
parts (other than the basket) are missing. If there are missing or damaged parts, please call Medline
Customer Care toll free at 1-800-MEDLINE.
3. Lay the rollator down so that the seat is facing the floor. Cut the plastic ties from the rear wheels and
unfold the legs. Straighten the legs until the rollator unfolds.
4. Flip the rollator over so that the seat faces up. Insert front wheel (G) into frame. Insert C Clamp (J) into
frame.
5. Unfold the rollator by pushing down on the support rod (F) to spread apart the frame until the folding
brackets (I) are in full extension. Push the seat down into place.
6. Insert the handlebars (B) so that the handgrips (A) are aligned with the rear wheels. The brake cables
should be on the outside of the handlebars and frame. Ensure excess brake cable loops out the front
of the rollator.
7. Adjust the height of the handlebars (B) for proper fit. To determine proper height, stand upright
behind the rollator with shoulders relaxed, arms hanging at your side and eyes looking straight ahead.
Standing in this position, the handgrips (A) of the rollator should be adjusted to a height even with the
wrists. This will position the arms at an approximate 20º to 30º bend when using the rollator. Secure
the handlebars at the closest hold to the desired height. Insert and tighten the triangular hand screws
until secure. See Figure 2. (Important: Hand Tighten Only!)
8. Insert the padded backrest (C) so that the padded portion faces the front of the unit. Push down on the
buttons on the side of the backrest until the spring pins lock into place.
9. Place the basket under the seat.
G-MDS86825 (GPI171)
Revised: 2/8/2010
5
Publicidad
