Front Runner FADR002 Manual De Instrucciones página 3

2
FIT AND SECURE
2.1
2.2
2.3
180mm
100mm
FRONT
FADR002_REV_A00
1265mm
1165mm
735mm
715mm
Discard
Discard
Discard
3
Using a flat screw driver and starting from
the front of the vehicle, lift and remove the
two ditch moldings running along either side
of the roof.
Remove all the retaining clips using a long
nose plier as shown.
Lay the left-hand ditch moulding on an
even surface. From the front tip of the ditch
moulding, measure and mark as shown.
Using a hacksaw, cut the ditch moulding at
each marking.
Discard the three smaller pieces and refit
the retaining clips to the four cut ditch
mouldings making sure the retaining clips
line up with the clip pins in the ditch.
Repeat this for the right-hand moulding.
© 2020 FRONT RUNNER VEHICLE OUTFITTERS