General Safety Instructions; Special Safety Instructions For This Device - BOMANN HTD 899 CB Instrucciones De Servicio

General Safety Instructions

Read the operating instructions carefully before putting the
appliance into operation and keep the instructions including the
warranty, the receipt and, if possible, the box with the internal
packing. If you give this device to other people, please also pass
on the operating instructions.
• The appliance is designed exclusively for private use and for
the envisaged purpose. This appliance is not fi t for commer-
cial use. Do not use it outdoors. Keep it away from sources
of heat, direct sunlight, humidity (never dip it into any liquid)
and sharp edges. Do not use the appliance with wet hands.
If the appliance is humid or wet, unplug it immediately.
• When cleaning or putting it away, switch off the appliance
and always pull out the plug from the socket (pull the plug
itself, not the lead) if the appliance is not being used and
remove the attached accessories.
• Do not operate the machine without supervision. If you
leave the room you should always turn the device off.
Remove the plug from the socket.
• The device and the mains lead have to be checked regularly
for signs of damage. If damage is found the device must not
be used.
• Do not try to repair the appliance on your own. Always
contact an authorized technician. To avoid the exposure
to danger, always have a faulty cable be replaced only by
the manufacturer, by our customer service or by a qualifi ed
person and with a cable of the same type.
• Use only original spare parts.
• Pay careful attention to the following "Special Safety Instruc-
tions".
Children and Frail Individuals
• In order to ensure your children's safety, please keep all
packaging (plastic bags, boxes, polystyrene etc.) out of their
reach.
WARNING!
Caution! Do not allow small children to play with the foil
as there is a danger of suffocation!
• This device is not intended to be used by individuals (includ-
ing children) who have restricted physical, sensory or mental
abilities and/or insuffi cient knowledge and/or experience, un-
less they are supervised by an individual who is responsible
for their safety or have received instructions on how to use
the device.
• Children should be supervised at all times in order to ensure
that they do not play with the device.
Symbols in these Instructions for Use
Important information for your safety is specially marked. It is
essential to comply with these instructions in order to avoid ac-
cidents and prevent damage to the machine:
WARNING:
This warns you of dangers to your health and indicates
possible injury risks.
05-HTD 889 CB.indd 17
CAUTION:
This refers to possible hazards to the machine or other
objects.

NOTE: This highlights tips and information.

Special safety instructions for this device

Symbols on the Product
On the products you will fi nd symbols that indicate warnings or
provide information:
WARNING OF ELECTRIC SHOCK!
Do not use this device near baths, wash basins or
other vessels containing water.
WARNING:
• The nozzles become hot during operation.
• If the hair dryer is used in the bathroom, remove the mains
plug after use as water represents a hazard. This also
applies when the hair dryer is switched off.
• Do not put objects, hair or your hands in front of the air
intake opening! The device can suffer damage despite the
overheating protection if the airfl ow is blocked!
• Please ensure that the inlet grille remains free of fl uff and
hairs. Danger of fi re!
As additional protection we recommend the installation of a fault
current protection device (RCD) with a rated current of not more
than 30 mA in the wiring system of the bathroom. Please contact
an authorised electrician for advice.
Commissioning
• Turn the handle to the on position.
• Fully unwind the mains cable.
• Fit on a nozzle.
• You can dry single hair locks by concentrating the fl ow
of hot air with the hairdressing nozzle.
• The diffuser is the ideal solution to dry curly hair without
losing volume.
• In order to replace the attachment, fi rst remove the old
attachment by pulling it off and then pushing on the new one
until it clicks into place.
• Only connect the machine to a properly installed safety
socket, 230 V/50 Hz.
Setting the Temperature Level (right switch):
Position : low temperature
Position : m edium temperature for gentle drying
and shaping.
Position : h igh temperature for rapid drying.
Setting the desired blower strength (left switch):
Position 0: off
Position : gentle stream of air
Position : strong stream of air
17
27.11.2009 13:29:30 Uhr