Publicidad
Idiomas disponibles
Idiomas disponibles
Figure 7
Handle
Before May 2015
Figure 8-1
Handle
After April 2015
Figure 8-2
Apply pressure to lock
Figure 9
Amano Pioneer Eclipse Operator's Manual FM 1700HD
All manuals and user guides at all-guides.com
HOW TO OPERATE THE MACHINE
NOTE: You must have training in the operation of this machine before
you use this machine.
Lift the locking lever to unlock the handle. Lower the handle to the best
position. Bend your arms and keep your back straight. To fasten the
handle, press down on the locking lever with your foot. Hold the handle
against your body for the best control. See Figure 7.
HOW TO CONTROL THE MACHINE
NOTE: Make sure you hold the handle with both hands.
The side to side movement of the machine is controlled by raising the
handle and pressing down on the handle. To move the machine to the
left, press down on the handle slightly. To move the machine to the right,
raise the handle slightly.
HOW TO START/STOP THE MACHINE
The switch to start and stop the machine is activated by the interlock
switch and the levers under the handle grips. See Figures 8-1 & 8-2. To
start the machine, follow this procedure:
NOTE: Make sure you hold the handle with both hands.
NOTE: Hold the handles loosely for the best control of the machine.
Too much movement makes the machine difficult to control.
WARNING:
Machines can cause flammable materials and
vapors to burn. Do not use this machine with
or near matches, fuels, grain dust, solvents,
thinners, or other flammable materials.
CAUTION:
This machine will operate only on the AC
frequency and electrical voltage shown on the
nameplate. Make sure you have the correct
frequency and voltage before connecting the
power cord to an outlet.
POSITION OF THE HANDLE
FOR OPERATION
WARNING:
Never start a polisher when the handle is in the
vertical position.
1. Lower the handle.
2. Lock the handle in the best position for operation. See Figure 9.
WARNING:
Control the safety interlock switch with hands
only.
3. Push the interlock switch, and apply pressure to the levers.
WARNING:
Water solutions or cleaning materials used with
this type of machine can leave wet areas on the
floor surface. These areas can cause a dangerous
condition for the operator or other persons.
Always put CAUTION signs near the area being
cleaned.
EN
ENGLISH
7
Publicidad
