Porter & Cable PCCK607 Manual De Instrucciones página 11

®
The RBRC Seal
The RBRC® (Rechargeable
Battery Recycling Corp oration)
Seal on the nickel cadmium,
nickel metal hydride or lithium-
ion batteries (or battery packs) indicates
that the costs to recycle these batteries
(or battery packs) at the end of their useful
life have already been paid by PORTER-
CABLE. In some areas, it is illegal to
place spent nickel cadmium, nickel metal
hydride or lithium-ion batteries in the trash
or municipal solid waste stream and the
Call 2 Recycle® program provides an
environmentally conscious alternative.
Call 2 Recycle, Inc., in cooperation
with PORTER-CABLE and other battery
users, has established the program in the
United States and Canada to facilitate the
collection of spent nickel cadmium, nickel
metal hydride or lithium-ion batteries. Help
protect our environment and conserve
natural resources by returning the spent
nickel cadmium, nickel metal hydride
or lithium-ion batteries to an authorized
PORTER-CABLE service center or to your
local retailer for recycling. You may also
contact your local recycling center for
information on where to drop off the spent
battery. RBRC® is a registered trademark
of Call 2 Recycle, Inc.
MAINTENANCE
WARNING
:
serious personal injury, turn tool off and
remove the battery pack before making any
adjustments or removing/installing
attachments or accessories. An accidental
start-up can cause injury.
CLEANING
WARNING
:
all air vents with clean, dry air at least once a
week. To minimize the risk of eye injury,
always wear ANSI Z87.1 approved eye
protection when performing this.
WARNING
:
other harsh chemicals for cleaning the non-
metallic parts of the tool. These chemicals
may weaken the plastic materials used in
these parts. Use a cloth dampened only with
water and mild soap. Never let any liquid get
inside the tool; never immerse any part of
the tool into a liquid.
Use only mild soap and damp cloth to
clean the tool. Never let any liquid get
inside the tool; never immerse any part of
the tool into a liquid.
To reduce the risk of
Blow dirt and dust out of
Never use solvents or
CHARGER CLEANING INSTRUCTIONS
WARNING
the charger from the AC outlet before
cleaning.
Dirt and grease may be removed from the
exterior of the charger using a cloth or soft
non-metallic brush. Do not use water or
any cleaning solutions.
REPLACEMENT PARTS
Use only identical replacement parts. For a
parts list or to order parts, visit our service
website at www.portercable.com. You can also
order parts from your nearest PORTER-CABLE
Factory Service Center or PORTER-CABLE
Authorized Warranty Service Center. Or, you
can call our Customer Care Center at
(888) 848-5175.
This Class B digital apparatus complies
with Canadian ICES-003.
This device complies with part 15 of the
FCC rules. Operation is subject to the
following two conditions: (1) This device
may not cause harmful interference,
and (2) this device must accept
any interference received, including
interference that may cause undesired
operation.
NOTE: This equipment has been tested
and found to comply with the limits for
a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits
are designed to provide reasonable
protection against harmful interference in
a residential installation. This equipment
generates, uses and can radiate radio
frequency energy and, if not installed and
used in accordance with the instructions,
may cause harmful interference to radio
communications. However, there is no
guarantee that interference will not occur
in a particular installation.
If this equipment does cause harmful
interference to radio or television
reception, which can be determined
by turning the equipment off and on,
the user is encouraged to try to correct
the interference by one or more of the
following measures:
• Reorient or relocate the receiving
antenna.
• Increase the separation between the
equipment and receiver.
• Connect the equipment into an outlet on
a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced
radio/TV technician for help.
Changes or modifications to this unit
11
:
Shock hazard. Disconnect