Mitsubishi Electric TRANE NTXUKS12A112A Serie Manual De Instrucciones página 8

● OPERATING INSTRUCTIONS ●
S
LEEP OPERATION
1
Press during COOL, DRY, HEAT or FAN mode
page 5 to select SLEEP operation.
Fan speed : AUTO
Horizontal vane : Position set on the remote controller
Operation indicator lamp : Dimly lit
2
Press (Increase) and
temperature of SLEEP operation.
• Once the above procedure is completed, the settings will be saved.
• After the settings are saved, a single push of
activates SLEEP operation with the same settings every time.
• Temperature for SLEEP operation cannot be set during DRY or FAN
mode.
3
Press again to cancel SLEEP operation.
• The operation returns to the previous settings.
• SLEEP operation is also cancelled when the FAN button is pressed or
the operation mode is changed.
Set temperature for SLEEP operation.
For about 30 minutes after
as set for the operation running when the SLEEP button is pressed. It
will change to the set temperature for SLEEP operation in about 30 min-
utes. Pressing again returns the operation to the previous settings.
is
pressed.
Set
temperature for
Set temperature for
the operation
SLEEP operation
before SLEEP
operation
For about 30
minutes
Note:
• ON/OFF timer is available during SLEEP operation.
• When a preset ON time for the weekly timer arrives during SLEEP operation,
the weekly timer operation has priority. SLEEP operation will be cancelled,
and the operation set on the weekly timer will start.
En-7
(Decrease) to set the
during operation
is pressed, the set temperature remains
is
pressed.
Set temperature for
the operation before
SLEEP operation
E
CONO COOL OPERATION
Press during COOL mode
ECONO COOL operation.
The unit performs swing operation vertically in various cycle according
to the temperature of the unit. Set temperature is set 4°F (2°C) higher
automatically.
Press again to cancel ECONO COOL operation.
• Pressing also cancels ECONO COOL operation.
What is "ECONO COOL"?
Swing airfl ow (change of air fl ow) makes you feel cooler than stationary airfl ow.
The set temperature and the airfl ow direction are automatically changed by the
microprocessor.
It is possible to perform cooling operation with keeping comfort.
As a result energy can be saved.
T
IMER OPERATION (ON/OFF TIMER)
1
Press or during operation to set the timer.
(ON timer) : The unit turns ON at the set time.
(OFF timer) : The unit turns OFF at the set time.
* or blinks.
* Make sure that the current time and day are set correctly.
2
Press (Increase) and
time of timer.
Each press increases or decreases the set time by 10 minutes.
• Set the timer while or
3
Press or again to cancel timer.
Note:
• ON and OFF timers can be set together.
operations.
• If power failure occurs while ON/OFF timer is set, see
function".
page 5 to start
Page 3
(Decrease) to set the
is blinking.
mark indicates the order of timer
page 5 "Auto restart