Publicidad
Idiomas disponibles
Idiomas disponibles
ICEMAKER INSTALLATION INSTRUCTIONS (cont.)
MOUNT THE ICEMAKER
6
• Hang the icemaker on the two mounting screws (10).
Mounting Screws
Make sure:
• The power cord is still firmly in the socket.
• The icemaker mounting screws are located in the
uppermost position of the mounting slots.
• The icemaker is level.
TIGHTEN THE ICEMAKER MOUNTING SCREWS
SECURELY.
7
INSTALL THE ICE BUCKET
Put the ice bucket (8) in
place under the icemaker.
Make sure the icemaker
power switch is set to OFF.
ATTACH WARRANTY LABEL
8
A label (7) is provided with this kit to record the date of
installation for warranty purposes. Apply it to the back of
the refrigerator.
REMOVE THE COVER
9
At the bottom rear of the refrigerator, remove the
screw(s) holding the access cover.
Bend the cover back for access to the compartment.
Be sure to save the screws as the access cover must be
reinstalled later to ensure your refrigerator will function
properly.
Installation Instructions
10
8
ATTACH THE WATER VALVE
10
• Locate the female connector plug. Plug the female
connector onto the male terminals on the water
valve. Either wire can go on either terminal.
Female
connector
FASTEN THE WATER VALVE
11
• Fasten the water valve (3) to the cabinet by driving
the Phillips-head screw (9) from the kit into the hole
in the cabinet leg.
3
INSTALL INLET TUBE SEAL
12
Peel one side of the paper away from the water fill tube
seal, slide the seal along the tube and affix to the back
side of the water tube inlet flange.
Water Inlet
Tube
11
9
Male
terminals
9
Gasket
5
Publicidad
