Mx Onda MX-PM2780 Manual De Instrucciones página 46

1. Switch and indicator on / off
2. Switch and indicator inside light
3. Popcorn kettle handle
4. Handle of the lid of the kettle
5. Main door handle
6. Folding door
7. Popcorn deposit
8. Measuring spoon for corn grains
9. Oil measuring spoon
USE OF THE POPCORN MACHINE
1. Check that the kettle is correctly attached to the supports, which is vertical
and the gears are engaged. Just as the kettle feeding plug is connected to
the connector of the main unit.
2. Insert the plug of the power cord into a 230 V mains socket with a ground
connection.
3. Turn on the popcorn machine using the on / off switch 1, and wait 3 to 5
minutes for the bucket to preheat. Once the bucket is hot, turn off the
popcorn machine with the on / off switch 1.
4. With great care to avoid burns, open the lid of the kettle with the handle 4,
and using the oil measuring spoon 9 pour a measure of oil into the inside of
the kettle (approximately 3/4 of the dosing spoon). This measure may vary
depending on the user's taste.
5. Completely fill the measuring spoon 8 with corn kernels and insert them
into the kettle.
VERY IMPORTANT:
Never add more or less corn grains than can fit in the measuring pan. If
you add less, the popcorn will come out very oily and if you add more, the
popcorn will not taste properly and you may get burned.
This product uses oil for its operation, do not put butter or other liquid
inside the kettle.
6. Once the corn grains and the oil have been poured into the kettle, close the
lid again with the handle 4.
7. Close the swing door 6 and then close the main door. If you do not close
the doors, it may happen that the popcorn is expelled to the outside.
8. Press the on / off switch 1 and the popcorn machine will start, after a few
minutes popcorn will start to pop into the popcorn machine reservoir 7.
The remover system that incorporates the kettle, mixes the oil with the
grains of corn and prevents the corn grains from burning.
6