Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
1. PARTS AND COMPONENTS
Fig. 2
1.
Main body
2.
Hose
3.
Water supply
4.
Water inlet
5.
High-pressure hose
6.
Water outlet
7.
Trigger gun
8.
Power socket
9.
ON/OFF switch
10. Wand
11.
3D TurboFlip nozzle
12.
Pulverizing
13.
Locking system
* Pieces 2, 3 and 8 not included
2. BEFORE USE
Box contents
-
HydroBoost 1500 EasyMove pressure washer.
-
High-pressure hose.
-
Spraying nozzle
-
3DTurboFlip nozzle
-
Trigger gun
-
Wand
-
Cleaning clip
-
Instruction manual
Ensure that all components are included and in good conditions. If any sign of visible damage
is observed or any of the product's parts are missing, immediately contact the official
Technical Support Service of Cecotec.
3. PRODUCT ASSEMBLY
-
Fit the high pressure hose (5) to the pressurised water outlet of the machine (6).
-
Attach the gun (7) to the high pressure hose (5). Before putting the machine into
operation, make sure that the high pressure hose (5) is completely unwound. The hose (5)
should not become entangled while in use.
64
HYDROBOOST 1500 EASYMOVE
-
Install the spray nozzle (12) or the item to be used.
-
Connect the machine to the power supply (8) and water supply (3).
4. OPERATION
Setting the water pressure
- The angle of the water jet can be set with the spray nozzle by turning the tip. This will
cause the jet to vary from approximately 0° (narrow high impact jet) to 60° (wide spray
jet). Fig .3
This device has 3 modes:
Concentrated mode
The angle of the water jet can be set with the spray nozzle. Rotate the nozzle to select
the direct jet, which has a high impact on the surface to be cleaned and provides thorough
cleaning of concentrated areas. This jet must be carefully used, as it can damage surfaces.
Fig. 4
Note
Pay special attention when cleaning surfaces susceptible to damage, such as vehicle
bodywork or rims, lacquered surfaces, wood, paintwork, etc.
Spray mode
Turn the spray nozzle to select the fan spray pattern to cover large areas. This cleaning mode
offers excellent results without the risk of damaging surfaces. By using a wide spray pattern,
larger areas can be cleaned more quickly. Fig. 5
Turbo mode
Use the 3D TurboFlip nozzle to clean with a turbo mode. Water is distributed in a spiral-
shaped jet. The 3D TurboFlip nozzle combines the power of a direct ject of great impact with
the efficiency of a 25º jet. This transforms the concentrated jet into a conical jet that deep
cleans larger areas. Fig. 6.
Product performance
Note
The motor of this pressure washer does not run continuously. It only runs when pressing the
trigger. Once the initial procedures in this manual have been carried out, turn the pressure
washer on and press the trigger to activate the pressure washer.
ENGLISH
HYDROBOOST 1500 EASYMOVE
65
Publicidad
