emmeti DN15 Manual De Instalacion Y Uso página 13

In both cases, it is necessary to specifically configure the energy meter (by means of PC+software
and optical feeler) or the impulse adaptor (by means of PC+software and Micro-Master). For the
configuration of these devices, refer to the dedicated instruction manuals. Important: it is possible
to extend the cable of the pulse emitter (reed switch) coming out of the volumetric meter for a
length not exceeding 10 meters, with a torque wrench and use a counter wrench for hold the counter
steady. Maximum tightening torque: 40 Nm. We also recommend the installation of a non-return
valve external to the meter. Vertical installations with downward flow or with the quadrant facing
are to be avoided downward. A seal is applied to the meter: it is not possible to open it tool without
breaking it. Every intervention must therefore be
carried out by an authorized center.
MID declaration of conformity
In relation to the volumetric counters described in this manual, the manufacturer declares that the
instruments are conform with the requisites of Directive 2014/32/EU MID dated 26/2/2014 on the
bases of the defined laws from single state members relative to the measuring instruments, in par-
ticular those in attachment MI-001.
Module B n. TMC 142/20-5700
Module D n. 0119-SJ-A010-08
ES
Índice
Gama ......................................................................................................................................................... 14
Construcción y características funcionales ........................................................................................... 14
Características dimensionales ............................................................................................................... 14
Rendimientos hidráulicos según directiva ............................................................................................. 15
Pérdidas de carga ................................................................................................................................... 15
Características técnicas ......................................................................................................................... 16
Instalación .............................................................................................................................................. 16
Conexión a la red M-Bus ........................................................................................................................ 16
Declaración de conformidad MID ........................................................................................................... 17
13