Publicidad
Idiomas disponibles
Idiomas disponibles
1. Small coffee cup and manual coffee
light
2. Manual brew button
3. Large cup of coffee and manual coffee
light
4. Small cup of cappuccino and milk foam
light
• Clean and prime the unit prior to first use.
• Please refer to the "Parts list" section to familiarize with the product and identify all
parts.
• Please make sure the unit is off "O" by pressing the switch located on the side of the unit.
Make sure it is unplugged from the electrical outlet.
• Remove stickers and labels from the unit.
• First remove and then wash the water tank, the milk tank, the two filters, the filter holder and
coffee spoon in a mixture of mild detergent and water. Rinse each thoroughly and place them
back into the unit.
• Refer to the instructions on "Inserting the filter" section before placing or removing the filter
holder and filter from the unit.
• To clean the inside of the appliance, follow the steps listed on the cleaning sections using
water in both tanks and no coffee in the filter. Do not immerse the appliance in water or at-
tempt to reach any of its internal parts.
• WARNING: Before the first use, you must remove the protective piece, situated on inferior
part of the water deposit, how tell the sticker.
NOTE: In order for your unit to work properly time after time, clean it after every use.
To prime the unit, run the steam cycle for 90 seconds by following the steps below:
CONTROL PANEL
Espresso
2
1
Cappuccino
5
4
Latte
7
8
BEFORE FIRST USE
3
6
9
5. Milk foam button
6. Large cup of cappuccino and milk foam
light
7. Small cup of latte and cleaning light
8. Cleaning button
9. Large cup of latte and cleaning light
E NGLI SH
9
Publicidad
