dormakaba Multiplexer Guia De Instalacion página 3

Introduction
The Multiplexer is used in multi-lock systems and allows multiple safe locks to connect with the Keypad.
Connect the Multiplexer
Follow these steps to connect a Multiplexer to a LA GARD safe lock system:
1. Mount the Multiplexer to the safe wall via the holes and screws provided; refer to the diagram below.
2. Connect each safe lock into the numbered input ports on the Multiplexer (up to 5).
Note: Input safe locks in numerical order, with the #1 input port on the Multiplexer always populated
first.
3. Connect the Keypad cable to the Multiplexer side port.
Specifications
Cables
1 x 26 AWG 6" cable (43109-3)
1 x 26 AWG 18" cable (41040-1) *
Environmental
Operating & Storage Temperature Range: For UL compliance, this product was verified for operation at 32 –
122 °F (0 – 50 °C)
Relative Humidity Range: 0 – 95% non-condensing
Note: The Multiplexer is not UL evaluated.
at an additional cost
dormakaba USA Inc. | Multiplexer Installation Guide 7038.0521 Rev B 03/22