Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATION
AUTOMATIC OPERATION
The unit is set to default to automatic
operation when it is first turned on. The air
purifier will automatically sense the amount of
impurities in the air, and adjust the fan speed
to keep your air purified.
MANUAL OPERATION
After you turn on the unit, you can switch
to manual operation by tapping the MODE
button.
• FAN SPEED 1, 2, OR 3
These levels are recommended for
standard daytime use. Fan speed 4 will
activate automatically when sensors detect
poor air quality.
• FAN SPEED 4
Fan speed 4, the highest fan speed, can
be activated manually for maximum air
purification.
Mode
PM2.5
Air quality indicator shows levels of air quality
on the display screen.
AeraMaxSV_412542_3L_021622.indd 8-9
8
CARE AND MAINTENANCE
CLEANING
• Clean unit as necessary by wiping with a
dry, soft cloth; for stubborn stains, use a
warm, damp cloth.
• Do not use volatile fluids such as
benzene, paint thinner, or scouring
powder, as they may damage the
unit surface.
• Keep the unit dry.
Filter Replacement
The screen displaying "END" will signal
when to replace the Combination Filter. The
replacement period will vary depending on
the hours of use and air quality. However,
under normal usage, they will need to be
replaced every two years.
Do not wash and reuse the True HEPA
or Carbon Filters—they will not work
effectively. Only use Fellowes brand
AeraMax™ replacement filters.
WARNING:
Before replacing any
filters, make sure to remove the
power plug from the wall outlet.
Replacement Procedure
1. Open filter doors.
2. Remove and dispose of old filters.
3. Remove any packaging wrap from the
new filter(s).
For replacement filter part numbers, see
page 4.
4. Place the new filters in the main unit.
Place filters HEPA-side-out and slide
them in until fully seated back in the
machine.
②
①
5. Close filter doors securely by inserting
the two tabs on the bottom of the door
first and then pivoting it closed. Repeat
for both doors.
6. To reset the filter timer once a Filter is
installed:
a. B e sure that drawer is closed.
b. Turn on the unit.
c. P ress the LOCK and TIMER buttons
at the same time for 3 seconds. This
will make the display stop saying
"END" and reset the filter life timer.
9
2/16/22 2:38 PM
Publicidad
