Xiaomi S10 Manual De Usuario página 10

Pausing
When the robot vacuum is running, press any bu on to pause. Press the
bu on to resume cleaning.
Note: The robot vacuum will enter sleep mode a er being paused or in standby mode
for five minutes. Press any bu on to wake it up.
Adding Water or Cleaning the Mop Pad
When the robot vacuum is working, pause it first then remove the 2-in-1
dust compartment with water tank to add water or clean the mop pad.
Then reinstall the 2-in-1 dust compartment with water tank and press the
bu on to resume the task.
Docking & Charging
When the robot vacuum is working, press the bu on
and press the bu on again to send the robot vacuum to return to the
dock to charge.
When the robot vacuum is in standby mode and not connected to the
charging dock, press the bu on
the dock to charge. When a task is complete or the ba ery is too low, the
robot vacuum will automatically return to the dock to charge.
DND mode
In the do not disturb (DND) mode, the robot vacuum does not resume
cleanup, perform scheduled cleanups or play voice prompts, and the
indicator turns off a er one minute of charging. The DND mode can be
enabled or disabled in the app.
Note: Please refer to the app for more features, including Clean There, Resume
Cleanup, Scheduled Cleanup, and Virtual Walls.
Notes:
When using the robot vacuum for the first time, please follow the in-app prompts to
complete quick map creation. To ensure accurate mapping, it is recommended to
follow the robot vacuum and remove any obstacles on the ground when it is creating
the map. Make sure the robot vacuum starts from the charging dock.
If the robot vacuum may get stuck or scratch the surface of the furniture in some
areas, you can set restricted areas in the app to prevent the robot vacuum from
entering those areas.
to pause the task,
to send the robot vacuum to return to
Care & Maintenance
Brush and Side Brush
1. Remove the side brush.
2. Press and hold the clips to remove the brush cover, then remove the
brush, and pull out the brush bearing.
3. Use the cleaning brush to clean.
Press and hold the
clips to remove.
Side Brush
Cleaning the Brush
Cut the hair
Notes:
For cleaning and maintaining the 2-in-1 dust compartment with water tank & mop
pad assembly, please refer to the labels on the tank and mop pad holder.
It is recommended to clean the cliff sensor every three months with a so cloth.
Please refer to the table for accessory replacements to ensure the optimal
cleaning effect.
Components Maintenance Frequency
Side brush Every two weeks
Brush
Weekly
Filter Weekly
Brush cover /
Mop pad
A er each use
08
Brush Cover
Clip
Brush
Brush Bearing
Remove dirt and debris
Replacement Frequency
Every 3–6 months
Every 6–12 months
Every 3–6 months
Every 3–6 months (or upon worn)
Every 3–6 months (or upon worn)