Worx WG264E Manual Del Usuario página 10

VIBRATION INFORMATION
Vibration total values (triax vector sum)
determined according to EN 62841:
Vibration emission value: a
Uncertainty K = 1.5m/s²
The declared vibration total value and the declared
noise emission value have been measured in
accordance with a standard test method and may be
used for comparing one tool with another.
The declared vibration total value and the declared
noise emission value may also be used in a
preliminary assessment of exposure.
WARNING: The vibration emission value
during actual use of the power tool can differ
from the declared value depending on the ways in
which the tool is used dependant on the following
examples and other variations on how the tool is used:
How the tool is used and the materials being cut or
drilled.
The tool being in good condition and well maintained
The use the correct accessory for the tool and
ensuring it is sharp and in good condition.
The tightness of the grip on the handles and if any
anti vibration accessories are used.
And the tool is being used as intended by its design
10
and these instructions.
This tool may cause hand-arm vibration syndrome
if its use is not adequately managed.
WARNING: To be accurate, an estimation of
exposure level in the actual conditions of use
should also take account of all parts of the operating
cycle such as the times when the tool is switched off
and when it is running idle but not actually doing the
job. This may significantly reduce the exposure level
over the total working period.
Helping to minimise your vibration exposure risk.
ALWAYS use sharp chisels, drills and blades
Maintain this tool in accordance with these
instructions and keep well lubricated (where
appropriate)
If the tool is to be used regularly then invest in anti
vibration accessories.
Plan your work schedule to spread any high vibration
tool use across a number of days.
4.INTENDED USE
The machine is intended for cutting and trimming
hedges and bushes in domestic use.
Cordless Hedge Trimmer
<2.5 m/s
2
h
5.OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
WARNING! Do not use the product without
attaching the guard and front handle.
ASSEMBLY & OPERATION
ACTION
ASSEMBLY
Assembling the safe guard
Assembling the Front Handle
NOTE: Loosen the long screw first
before assembling the front handle.
NOTE: If the handle is assembled
incorrectly, the tool will not power on.
Checking the battery charge condition
Installing and Removing the battery pack
Charging the battery pack
Your battery pack is UNCHARGED, you
must charge before use.
More details can be found in charger's
manual
OPERATION
Starting and stopping
Top cutting
WARNING: If any parts are
missing, damaged or broken, do
not operate your hedge trimmer until all
damaged parts have been replaced or
repaired. Failure to do so could result
in serious personal injury. DO NOT
USE WITHOUT FRONT HANDLE AND
SAFETY GUARD.
Side cutting
Lubricating the Cutting Blade
NOTE: It is important to use only the
recommended standard lubricating oil
(WD-40) to avoid damage to the blade.
HOW TO USE YOUR HEDGE
TRIMMER
Note that the front switch lever can be activated
on three sides, giving you many choices for a
comfortable grip. Before cutting an area, inspect
it first and remove any foreign objects that could
FIGURE
See Fig. A
See Fig.
B1, B2, B3
See Fig. C
See Fig. D
See Fig.
E1, E2
See Fig.
F1
See Fig. F2
See Fig. G
EN