Kuppersbusch KI6130.0SE Manual Del Usuario página 16

Fig. 3
Some pans without a complete
ferromagnetic base are sold as
suitable for induction (see fig.3). In
these pans, only the ferromagnetic
base is heated. Consequently the
heat is not evenly distributed across
the base of the pan. This may mean
that the non-ferromagnetic part of the
base of the pan does not reach the
right cooking temperature.
Fig. 3
Other pans, with aluminum inserts
in the base have a smaller area of
ferromagnetic material (see fig.4).
In this case, it may be difficult or
even impossible to detect the pan. In
addition, the power supplied may be
lower and, consequently, the pan will
not heat up correctly.
Fig. 4
Influence of the base of the pans
The type of base used on the pan
may affect the uniformity and results
of the cooking. Pans with a stainless
steel "sandwich" base use materials
that assist the uniform distribution
and diffusion of the heat, resulting in
savings in time and energy
The base of the pan must be
completely flat, thus ensuring a
uniform power supply (see fig.5).
Fig. 5
Never heat empty pans, or use
pans with a thin base, as these may
heat up quickly without allowing time
for the automatic disconnection
function of the cooker to come into
operation.
Use and
Maintenance
User instructions of the
Touch Control
HANDLING ELEMENTS (fig. 6)
1
General on/off sensor.
Cursor slider for controlling power.
2
Power and/or residual heat
3
indicator*.
Decimal dot of power and/of
4
residual heat indicator.
Direct access to "Power" function.
5
Activation sensor for "Block"
6
function.
Pilot indicator light "Block"
7
function activated*.
Activation sensor for "Stop&Go"
8
function.
Pilot indicator light "Stop&Go"
9
function activated*.
10
"Minus" sensor for timer.
11 "Plus" sensor for timer.
Timer indicator.
12
Decimal dot of the timer.*
13
* Only visible while running.
The manoeuvres are done by means
of the touch keys. You do not need
to exert force on the desired touch
key, you only need to touch it with
your fingertip to activate the required
function
Each action is verified by a beep.
Use the cursor slider (2) to adjust
power levels (0 - 9) by sliding your
finger over it. Sliding towards the right
increases the value, whereas sliding
towards the left decreases it.
It's also possible to directly select a
power level by placing your finger
directly on a desired point of the cursor
slider (2)
In order to select a plate on
these models, directly touch the
cursor slider (2).
SWITCHING ON THE DEVICE
1 Touch the On touch key
least one second. The touch control
will become active, a beep will be
heard and the indicators (3) will light
up displaying a "-". If any cooking
area is hot, the related indicator will
flash an H.
If you do not take any action in the
next 10 seconds the touch control will
switch off automatically.
When the touch control is activated,
you can disconnect it at any time by
touching the touch button
if it has been locked (lock function
activated). The touch button
always has priority to disconnect the
touch control.
ACTIVATING PLATES
Once the Touch Control is activated
with sensor (1), any plate can be
turned on by following these steps:
1 Slide the finger or touch in any
position of one of the cursors
"slider" (2). The zone has been
selected and simultaneuously the
power level will be set between 0
and 9. That power value will be
EN
(1) for at
(1), even
(1)
15