Publicidad
Idiomas disponibles
Idiomas disponibles
2. Next to the power cord connector there are two plastic knobs where the fuses are housed.
Manually turning these knobs in the direction indicated by the arrows, both handles can be
removed, one at a time, to replace damaged fuses.
3. Remove the damaged fuses and replace them with the spare fuses, to do this use the same
value of the replaced fuses.
Only use fuses as shown at the rear side of the PROCAM HD console and certified by
IEC60127.
4. Screw again the knobs.
5. Connect the power cord.
DEGREE OF PROTECTION AGAINST
HARMFUL ENTRY OF LIQUIDS AND
POWER CONSUMPTION
OPERATING CONDITIONS
STORAGE AND TRANSPORT
INMANUUML023 USER M./M.USO PROCAM HD BASIC V.2022.10 ENG/ESP US
7. TECHNICAL SPECIFICATIONS
POWER SUPPLY
Nº OF PHASES
FRECUENCY
CLASS
APPLIED PART
USE MODE
SOLIDS
FUSES
VIDEO OUTPUT*
RESOLUTION
SENSOR
CONDITIONS
WEIGHT
USER MANUAL – PROCAM HD II
100 - 240 V
1 (SINGLE PHASE)
50 – 60 HZ
I
B TYPE
CONTINUOUS
IPX0
25 VA
2 X T2AL250V
2 X HDMI
1920 (H) X 1080 (V) @ 60 FPS
1/3" CMOS
10 – 40 ºC (50 – 104 ºF)
35 – 75 % RELATIVE HUMIDITY
700 – 1060 HPA
-30 – 50ºC (-22 – 122ºF)
10 – 95% RELATIVE HUMIDITY
500 – 1060 HPA
CAMERA 0.66 LBS - 0.30 KG
Página 11 de 30
Publicidad
