Publicidad
Idiomas disponibles
Idiomas disponibles
TERMAT TWOxxx_ES_EN_ver3_Julio'23
1) The"1" refers to the water heater power switch button and mode button.
press this button for 3 seconds, the system boot, the display light, and vice versa. At boot mode: press
this button, then switch between "single tank mode", "double tank mode" or "smart mode". If electricity
fall dawn suddenly, the water heater restarts in previous selected mode. Only if model is "smart" one,
appliance starts again in "single tank" mode.
2) The "2" refers to the temperature regulating knob of the water heater. This knob is adjusted by 360
degrees, clockwise rotation, increasing temperature, anticlockwise rotation, and decreasing
temperature. During the rotation, the "7" number of the display screen changes accordingly. When you
enter the smart mode, you can't adjust the setting temperature, and the system starts the intelligent
control program by default
3) The "3" is a single tank model indicator lamp. When the user sets the water heater as a single tank
mode, the indicator light is lit and the display is white
4) The "4" is the double tank model indicator lamp. When the user sets the water heater as the double
tank mode, the indicator light is lit and the display is white.
5) The"5" for the power indicator. The water heater is energized and the indicator light is lit to show blue.
If users choose smart mode, flashing display.
6) The "6" as the heating indicator light, water heater in the heating state, indicator light shows red; if the
water heater is not heated, the lights go out.
2.- CLEANING.
The external parts of the water heater may be cleaned with a mild detergent solution. Do not use solvents and
abrasives.
Never try to repair any possible faults of the water heater by yourself, but inform about it the
3.- LEGIONELLA THERMAL DISINFECTION CYCLE
In order to reduce the proliferation of Legionella inside the electric water heater, disinfection cycles should be carried out
with the recommended frequency in the following cases:
1)
If the device is disconnected for more than a month, a disinfection cycle must be carried out when it is switched on.
2)
If the water temperature is kept constantly below 55°C on a regular basis, a disinfection cycle should be carried out at
least every three months.
Fig. – 6
nearest authorised service workshop.
13
I
n the shutdown state, long
Publicidad
