Sicce FILTRAPOND Manual De Instrucciones página 4

Always disconnect the pump when not in use, before adding or removing parts and before cleaning.
- Do not allow the ¿ lter to run dry. ALL-IN-ONE must be immersed in water completely.
- This appliance is to be used in a circuit protected by a ground fault circuit interrupter.
- To reduce the risk of electric shock, install only on a circuit protected by a Ground - Fault Circuit -
Interrupter (GFCI).
- This appliance has not been investigated for use in swimming pool or marine areas.
- To avoid possible electric shock, special care should be taken since water is employed in the use of pond equipment.
For each of the following situations, do not attempt repairs by yourself. Return the appliance to an authorized service
facility for service or discard the appliance.
1) Do not operate any appliance if it has a damaged cord or plug, or if it doesn't work properly or has been dropped or
damaged in any manner.
2) To avoid the possibility of the appliance plug or receptacle getting wet,
position the ¿ lter to one side of a wall-mounted receptacle to prevent water
from dripping onto the receptacle or plug.
A "drip-loop" (Fig. A) should be arranged by the user for each cord connecting
a pond ¿ lter appliance to a receptacle. The "drip-loop" is the part of the cord
below the level of the receptacle or the connector if an extension cord is
used, which prevents water travelling along the cord and coming in contact
with the receptacle.
If the plug or socket does get wet, DON'T unplug the cord. Disconnect the
fuse or circuit breaker that supplies power to appliance. Then unplug and
examine for presence of water in the receptacle.
3) Close supervision is necessary when any appliance is used by near
children.
4) To avoid injury, do not contact moving parts or hot parts such as heaters,
reÀ ectors, lamp bulbs and similar.
5) Always unplug an appliance from an outlet when not in use, before putting
on or taking off parts and before cleaning. Never yank cord to pull plug from
outlet. Grasp the plug and pull to disconnect.
6) Do not use an appliance for other than intended use. The use of
attachments, not recommended or sold by the manufacturer of the appliance,
may cause an unsafe condition.
7) Do not install or store the appliances where it will be exposed to the