Descargar Imprimir esta página

Bigben PARTY PARTYBTIPMS2 Manual De Instrucciones página 10

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 18
Getting started
Safety warning and notice
Contents of the box
Description of parts
Operation
Getting started
Take the appliance out of the box.
Remove all the packaging from the product.
Place the packaging inside the box or dispose of it safely in compliance with the waste
sorting instructions shown on the product packaging.
Safety warning and notice
You must read and understand all the instructions before using this appliance. The warranty
will not apply if damage is caused by failure to follow the instructions.
1. Never remove the appliance casing.
2. Never place this appliance on top of other electrical equipment.
3. Protect the power cord from being stepped on or pinched, particularly at
the plugs, sockets, and the point where it exits the appliance. Make sure
that the power voltage corresponds to the voltage shown on the rating plate
at the rear of the appliance. Always pull the plug from the socket when
disconnecting from the mains. Never pull on the cord. Ensure you have
completed all the other connections before connecting the plug.
4. Only use attachments/accessories that are recommended by the
manufacturer.
5.
Entrust all appliance repairs to qualified repairers. Repair is needed when the appliance
has been damaged in any fashion, and in particular:
- if the power cord is damaged;
- in the event of a liquid spill or objects being inserted into the appliance;
- if the appliance is exposed to rain or dampness;
- if the appliance does not operate normally;
- or if the appliance has been dropped or impacted.
6.
The series panel is located on the bottom of the appliance.
7.
Never block the air vents.
8.
Make sure you have enough space for ventilation. Place the product on a stable surface.
9.
This device must be used in a moderate climate, away from direct sunlight, naked flames
or heat, heating devices, cookers or any other devices (including amplifiers) that generate
heat. Do not install near a heat source.
10. The batteries (battery pack or inserted batteries) must not be exposed to excessive heat,
such as sunshine, fire, etc.
11. Always unplug the device before cleaning it. Never lubricate any part of this appliance.
10
Operation in pairing mode
10
Technical Specifications
12
Care of the environment
12
Additional information
13
Declaration of conformity
- EN 10 -
13
14
14
15
15

Publicidad

loading