Refco REFCLAMP Manual De Instrucciones página 14

7.0 ICE WATER CALIBRATION
4. If calibration is successful CAL PASS will blink 3x
Instruction Manual
Device must be switched off!
1. While pressing and holding
briefly press
*Code will blink 3x
2. Select Code 9 for Ice water
Calibration:
Briefly press
number, then press and hold
to confirm the number.
*ICE will blink 3x
3. Place the tip of the clamp in ice
water and confirm by briefly
pressing
Temperature must be between -5
°C and 5 °C (23°F to 41 °F),
otherwise the calibration will not
be performed
,
to adjust the
11