KitchenAid 5KES6403 El Manual Del Propietario página 6

GETTING STARTED (CONTINUED)
5.
To rinse the Group Head, place a container under the Group Head. Toggle the Mode
Button to select Espresso. Toggle Dose Button to 1 and press
will flush water through the Group Head and automatically stop when the cycle is
complete.
6.
To rinse the Steam Wand, direct the Steam Wand towards the Drip Tray or into a cup.
Then, toggle the Mode Button to select Hot Water and press
water to flow for 3 to 5 seconds then, press
PRODUCT USAGE
BREWING ESPRESSO
1.
Select desired Filter basket. Press the Filter basket into the Portafilter until it clicks into
place.
2.
Fill the Filter basket with fine Espresso coffee grounds.
3.
Tap the Portafilter to level the ground coffee bed and rest on a flat surface. Use the Tamper
to tamp down the ground coffee. Sweep excess coffee grinds from the rim.
4. Position the Portafilter under the Group Head with the handle align to unlock. Raise the
Portafilter into the Group Head and twist to the right side to lock.
5.
Toggle Mode Button to select Espresso. Toggle Dose Button to select desired number of
shots 1 (~ 30 ml) or 2 (~ 60 ml).
6.
Press Button to run selected Espresso cycle.
NOTE: Do not remove the Portafilter when brewing.
TIP: Shot duration should be between 20-30 seconds for 1 and 2 shot selections.
- If less than 20 seconds: decrease grind size and/or increase tamp pressure.
- If more than 30 seconds: increase grind size and/or reduce tamp pressure.
PROGRAMMING FUNCTION
The Espresso Machine is equipped with programming functionality. Any customised
settings will be saved even in the event power is lost to the machine.
PROGRAMMING THE ESPRESSO AND HOT WATER AMOUNT
1.
To change pre-programmed Espresso Volume for 1 / 2: Toggle the Mode Button to
select Espresso. Select the dose you desire to programme (1 or 2). Press and hold
Button until desired espresso amount is reached in your cup. While programming your
selected dose, the dose and the
programming is complete.
2.
To change pre-programmed Water Volume for 1 / 2: Toggle the Mode Button to select
Water. Select the dose you desire to programme (1 or 2). Press and hold
desired water amount is reached in your cup. While programming your selected dose, the
dose and the
complete.
NOTE: To restore all factory settings, Press and Hold "Dose Button" for 3 seconds.
Changing the factory default Espresso or Water Volumes may impact the intended
performance of the machine.
6
Button light will blink. Lights will stop blinking when programming is
Button to stop.
Button lights will blink. Lights will stop blinking when
Button. The machine
Button to start. Allow
Button until