Publicidad
Idiomas disponibles
Idiomas disponibles
The supply voltage must match the technical
specifications of the power tool and it must be
grounded.
The power cord must be plugged into socket with
differential protection. The circuit breaker must be set to
trip when there is a maximum fault current of 30mA.
Do not expose the power tool to rain or operate it in wet or
damp conditions. The presence of water in a power tool
increases the risk of damage and electric shock to the user.
Never use the power cord to pull, carry or unplug the power
tool. Damaged power cords increase the risk of electric
shock.
Keep the power cord and plug away from heat sources, oil,
sharp objects.
Check the condition of the power cord regularly, if it is
damaged, it must be replaced or repaired by a qualified
technician. Do not touch it and unplug from the socket
immediately. Never operate the power pool if the power
cord is damaged.
Never change the power cord's plug and use a socket which
is compatible with the plug. Do not use any kind of socket
adaptor.
The use of extension cords to plug in the power cord is not
recommended. However, if you use an extension cord, you
should take some precautions, such as:
▪ If you operate the power tool outdoors, use only
extension cords suitable for outdoor use. The use of a
suitable extension cord reduces the risk of electric
shock;
▪ Use only extension cords, plugs and sockets with earth
terminal;
▪ The cross-section of the extension cord's conductors
shall be proportional to the length and with the same
characteristics as or larger than the hot air gun's power
cord;
▪ Do not use damaged extension cords. Examine the
extension cords before using them and replace if
necessary;
▪ Always unplug the extension cord before removing the
plug from the power tool;
▪ When using an extension cord reel, unroll the cord
completely.
Individuals who have not read the instruction manual and
are not familiarized with how to operate the hot air gun
must not use it.
Ensure that the ambient air does not contain high
concentrations of dust, acid vapours, gases or flammable
substances. You should be particularly careful when
carrying out repair work on pipes and tanks which contain
or have been used to stock combustible liquids or gases.
To ensure that you operate the power tool safely, you
should consider a few precautions and procedures before
start-up:
▪ Check that the accessories are assembled correctly and
in good condition. Never use damaged accessories;
▪ Replace defective or damaged parts as well as all other
used and worn-out parts;
▪ Check that the safety devices are in perfect condition
and function properly. Never use the power tool if the
safety devices are missing, inhibited, damaged or worn
out.
Make all adjustments and work necessary for the correct
assembly of the power tool if you have any questions or
difficulties, contact your official dealer.
Publicidad
