RIDGID 122 Manual Del Operador página 6

122 Copper Cutting and Prep Machine
maximum wall thickness of .065". The cutting of stainless
steel requires the use of a special cutter wheel and wheel
pin. See Accessory Section of this manual for listing of
Catalog Numbers.
Specifications
Capacity ........................ 1 /
2
Copper Tube & Fittings
(Types K, L, and M)
(Stainless Steel Tube 0.065
Maximum Wall Thickness)
Motor:
Type ............................115V/60Hz Induction
Horsepower.................1/3 HP @ 1750 RPM
Amps...........................6.0
Switch ............................Rocker Type
Weight............................50 lbs. (22.7 kg)
Dimensions:
Height..........................14.6" (37 cm)
Width...........................16.8" (43 cm)
Depth ..........................15.1" (38 cm)
Standard Equipment
Model No. Cat. No. Description
122 93492 Copper Cutting and Prep Machine
115V, 60Hz w/Reamer and O.D/I.D.
Brushes
Accessories
Cat. No. Description
46105 Outside Debur Disk
33551 Stainless Steel Cutter Wheel (Requires Special
10343 Wheel Pin)
10343 Cutter Wheel Pin for 33551 Cutter Wheel
36662 Model 301A Foot Switch -120V
Figure 1 – 122 Copper Cutting and Prep Machine
4
All manuals and user guides at all-guidesbox.com
" – 2" Diameter
Ridge Tool Company
Fitting
Brushes
Adapter
Figure 2 – Fitting Brushes/Quick-Change Adapter,
Outside Deburring Disk, and Mounting
Hardware
Machine Assembly
WARNING
To prevent serious injury, proper assembly of the No.
122 Copper Cutting and Prep Machine is required.
The following procedures should be followed:
Make sure machine is unplugged from
WARNING
power source before assembling accessories or making
any adjustments.
Fitting Brushes and Holder
1. Mount the fitting brush holder to No. 122 Copper
Cutting and Prep Machine by using the two Phillips
head screws provided with the rack (Figure 2). Use
the two pre-drilled holes to fasten the rack to the
side of the housing.
2. Attach the quick change adapter (Figure 2) to front
roller shaft extending from the machine housing using
the set screw provided. Use Allen wrench to tighten
screw onto the flat on the shaft.
Outside Debur Disk
(Optional Accessory)
1. Outside deburring disk must be mounted at the back
of the outside tube brush (Figure 3).
2. To remove brush, hold shaft stationary by gripping flat
located near the surface of the housing.
3. Remove 1 / " nut and washer from the shaft.
2
4. Remove the brush and spacer (Figure 3).
5. With the model number F-4697 (stamped on the
side of the deburring disk) facing towards the
machine housing, slide deburring disk onto the shaft
and replace the brush. Spacer is not needed when
disk is installed.
Deburring Disk