RIDGID 122 Manual Del Operador página 11

122 Copper Cutting and Prep Machine
Replacement Cutter Wheels/Cleaning
Brushes
Model No. Cat. No. Description
E-2191 33175 HD Copper Cutter Wheel
— 42295 Outside Diameter Cleaning Brush
Cat. No. Description
93717 1 / " Fitting Brush (Pkg. of 3)
2
93722 3 / " Fitting Brush (Pkg. of 3)
4
93727 1" Fitting Brush (Pkg. of 3)
93732 1 1 / " Fitting Brush (Pkg. of 3)
4
93737 1 1 / " Fitting Brush (Pkg. of 3)
2
93742 2" Fitting Brush (Pkg. of 3)
93747 Quick-Change Adapter f/Fitting Brush
93712 Fitting Brush Holder
93707 Fitting Brush Kit
— 1 / ", 3 / ", 1", 1 1
2 4
— Quick-Change Collet
— Storage Rack
— Mounting Hardware
— Spare Cutter Wheel (E-2191)
Pipe Stands Recommended For Use
with No. 122 Copper Prep Machine
• VJ98
• RJ99
Maintenance Instructions
WARNING
Make sure machine is unplugged from power
source before performing maintenance or mak-
ing any adjustment.
Lubrication
Keep a light coat of oil on the rack and pinion and the
cutter wheel shaft.
NOTE! No lubrication of the rollers is required.
Rollers
Keep rollers clean and free from dirt and debris.
Cutter Wheel Replacement
Cutter wheel is considered worn when cutting edge
becomes ragged.
1. Loosen shoulder bolt and remove hold down wheel
carriage (Figure 11A). Insure that the shoulder bolt
remains inserted in arbor to keep tension spring in
place.
All manuals and user guides at all-guidesbox.com
/ " 1 3 / ", 2" Brushes
2 4
Ridge Tool Company
2. Remove cutter wheel screw and replace cutter wheel
(Figure 11B).
3. Reinstall hold down wheel carriage and tighten shoul-
der bolt.
Figure 11A – Loosen Shoulder Bolt
Figure 11B – Remove Cutter Wheel Screw
O.D. Brush Replacement
Brush is considered worn when its bristles are uneven or
too short to effectively clean the tubing.
1. Hold shaft stationary by gripping flat located near
surface of housing.
2. Remove 1 / " nut and washer from the shaft and
2
replace the brush.
3. Reinstall nut and washer and tighten again holding the
shaft stationary.
9