Publicidad
Idiomas disponibles
Idiomas disponibles
3 m x 3 m · Aluminium/ Aluminum/ Aluminium 32 mm
During the Assembly
•
Take the item out of its storage bag.
Slightly extend the gazebo by slowly pulling on the opposite corner poles. (Dia.1)
•
•
Put the roof on the partly extended frame and make sure that the corners of the
uprights match the corners in the tarpaulin. Also, the centre pole must sit at the centre
point of the tarpaulin. (Dia.2)
•
Now fully extend the frame while adjusting the joints in each corner to a height
where the locking pins snap in to secure them. (Dia.3)
•
Note: If there is a lot of resistance, the item is not yet fully extended.
•
Attention: Fingers may get caught by the joints.
•
Pull the telescopic uprights out of the corner poles. To do that simply place your foot on
the base plate of the uprights and pull on the upper part until the pin snaps in. (Dia.4-5)
•
Note! You can choose between 3 or 5 different height levels.
•
Bring the roof to its final position. To do this, use the Velcro fasteners in the corners and
those sewn into the inside of the tarpaulin to connect the tarpaulin to the poles. (Dia.6)
•
Secure each upright by means of the pegs (3) that were included in the delivery. Simply
drive them through the holes in the foot plates. (Dia.10)
•
Attention! Please check that all pegs fit tightly and that the ground is not too soft.
•
Knot a guy rope with each loop at the outer corners of the roof. Tension the guy ropes
and fix them to the ground with pegs (Dia.11).
•
Attention! Please check that all pegs fit tightly and that the ground is not too soft.
•
Attach the side panels by means of the Velcro straps / plastic hooks attached to the
side panels (Dia.8).
Aluminium/ Aluminium/ Alluminio/ Aluminium/
Aluminium/ Aluminio
11
Publicidad
