Emerson RAH ECO Manual página 19

7. Wall Control Installation
7.5
This Control is designed to operate only one Ceiling Fan.
NOTE: Electric connections should be in accordance
with the National Electrical Codes and all Local
Codes. Before starting, disconnect power to the
circuit at the fuse box or circuit breaker panel.
Remove the Faceplate and Screws from the Existing Wall
Switch. Pull Switch out from Wall Outlet Box.
Determine the "Hot" Wire and the "Load" Wire and
disconnect these Wires from existing Control
(Figure 31).
Do not attempt to disconnect any Wires not already
connected to existing Control.
Skip to Section 7.7 if using a 3-way switch
installation.
SINGLE-POLE INSTALLATION
7.6
Disconnect Electrical Power to the Branch Circuit at the
Circuit Breaker or Fuse Box before attempting to install the
Ceiling Fan Wall Control into the Outlet Box.
Before installing Wall Control, place Wall Control in "OFF"
mode by pushing "ON/OFF" Switch to the "OFF" position.
WARNING
!
Do not connect any neutral (white) wire to this control.
Incorrect wiring will damage this control.
Connect the Wall Control Black Wire with the Yellow Label
marked "To Power Supply" to the "Hot" Wire in the Wall
Box. Securely connect Wires with Wire Connector
(supplied) (Figure 32).
Connect the Wall Control Black Wire with Blue Label
marked "To Fan" to the "Load" (Black) Wire in the Wall
Box. Securely connect Wires with Wire Connector
(supplied) (Figure 32).
Connect the Wall Control Green Ground Wire to the Bare
Copper Wire or Green Ground Wire in the Wall Box.
Securely connect Wires with Wire Connector (supplied)
(Figure 32).
(Continued)
SCREWS
Figure 31
!
Check to see that all connections are tight and that no
bare wires are visible at the wire connectors.
Screw Wall Control into Wall Box using the supplied
screws. Leave Wall Control in "OFF" mode until fan
installation is completed.
The Wall Control is supplied with a White, Ivory, and
Almond color Switch Covers. Choose the finish that best
suits your needs and snap the Cover onto the Wall Control
(Figure 32).
Install Decorator Wall Plate using the two screws provided
with Wall Plate. Leave Wall Control in "OFF" mode until
fan installation is completed (Figure 32).
SCREWS (2)
DECORATIVE WALL PLATE
Figure 32
19
WALL
SWITCH
FACEPLATE
WARNING
FAN/LIGHT
WALL CONTROL
SWITCH COVER
emersonfans.com
Please contact 1-800-654-3545 for further assistance
U.L. Model No.: CF915
OUTLET
BOX
WALL
BOX
NEUTRAL
WIRES