Emerson RAH ECO Manual página 6

3. Ceiling Fan Assembly
3.4
Loosen the two Phillips Head Set Screws in the Motor
Coupler for installation of the Downrod (Figure 4).
Seat the Downrod in the Motor Coupler (Figure 4).
3.5
Align the Clevis Pin holes in the Downrod with the holes in
the Motor Coupler.
Install the Clevis Pin and secure with the Hairpin Clip
(Figure 5).
The Clevis Pin must go through the holes in the Motor
Coupler and Downrod. It is critical that the Clevis Pin in the
Motor Coupler is properly installed and securely tightened.
3.6
While pulling up on the Downrod, securely tighten the two
Phillips Head Set Screws in the Motor Coupler (Figure 6).
NOTE: The Set Screws must be properly installed as
described above, or fan wobble could result.
WARNING
!
It is critical that the clevis pin and set screws in the motor
coupler are properly installed and securely tightened.
Failure to verify that the pin and set screws are properly
installed could result in the fan falling.
(Continued)
DOWNROD
MOTOR COUPLER
LOOSEN PHILLIPS
HEAD SET SCREWS (2)
Figure 4
DOWNROD
CLEVIS
PIN
MOTOR COUPLER
Figure 5
DOWNROD
MOTOR COUPLER
Figure 6
6
HAIRPIN
CLIP
CLEVIS
PIN
HAIRPIN
CLIP
RETIGHTEN
SET SCREWS
U.L. Model No.: CF915