Publicidad
Idiomas disponibles
Idiomas disponibles
10. Insert the hex-head bolts from the bottom and start the self-
locking nuts for each caster.
A. Self-locking nut
B. Caster bracket
⁵⁄₁₆
C.
–18 x
D. Caster
11. Hold the head of the hex-head bolts with a wrench while
tightening the self-locking nuts with a socket wrench.
12. Using a ¹⁄₂" socket wrench, remove the 4 unit bolts (2 on each
side) from the lower front and rear of the convertible refrigerator/
freezer.
NOTE: Do not remove leveling bolt.
Lower Front Corner
A. Leveling bolt (do not remove)
B. Unit bolt
13. Place the slot in the rear of the caster bracket over the hole in the
rear of the convertible refrigerator/freezer. Align the hole in the
front of the caster bracket with the hole in the front of the
convertible refrigerator/freezer.
8
A
B
C
D
⁷⁄₈
" hex-head bolt
A
B
Lower Rear Corner
A. Rear convertible refrigerator/freezer hole
B. Caster Bracket
14. Hold the bracket in place and insert the unit bolts into the front
and rear unit holes and tighten.
NOTE: Do not overtighten the bolts.
15. Insert 2 of the ¹⁄₄–20 x 1¹⁄₄" hex-head bolts and lock washers into
the 2 holes in the side of the caster bracket. Push the caster
bracket against the bottom of the convertible refrigerator/freezer
and tighten the bolts using a ³⁄₈" socket wrench.
A. Caster bracket holes
16. Repeat steps 12 – 14 for the second caster bracket.
Complete the Assembly
1. Lock the front caster wheels.
2. Insert a small piece of cardboard between the caster brake and
the floor. This will help prevent the brake from rubbing on the
floor.
3. Stand the convertible refrigerator/freezer upright.
4. Replace the base grille by placing the metal clips in the openings
in the metal panel and rolling the grille downward until it snaps
into place.
5. Unlock the wheels and move the convertible refrigerator/freezer
into its desired location.
6. After the convertible refrigerator/freezer is in position, relock the
wheels.
7. Plug in convertible refrigerator/freezer or reconnect power.
A
A
B
Publicidad
