General
IMPORTANT! Prevent unintentional
!
starting by removing the ignition cable
from the spark plug.
Handle
Assembly
Top handle
Place the handlebar's tubular construction in direct
opposite to the lower part of the handlebar. Tighten the
knobs properly.
Use enclosed straps to secure cables to the handle. Do
not overstretch cables when mounting.
Settings
Handle height
•
Loosen the lower knobs.
•
Adjust the height. Tighten the knobs properly.
66 – English
ASSEMBLING AND ADJUSTMENTS
Cutting height
NOTICE! Do not set the cutting height too low as there
is a risk that the cutters might hit ground with
unevenness.
Move the lever to the back for higher cutting height and to
the front for lower cutting height.
LM 2146CMD has 3 controls. Set the same height on all
three control points.