Publicidad
Idiomas disponibles
Idiomas disponibles
- In the event of flooding the internal electrical components as
well as the power base with water, dry them thoroughly before
re-connecting the kettle to the mains. Do not immerse the unit
or stand in water or other liquids.
- The device must not be used by children. Keep the device and
cable out of the reach of children.
- Disconnect the unit from the power supply if you leave it unat-
tended and before installation, disassembly or cleaning.
- WARNING! Do not let children play with foil. Danger of suf-
focation!
APPLIANCE OVERVIEW
1.
Housing
2.
Cover
3.
Button (lever) for opening the cover
4.
Kettle handle
5.
Control panel
a. on/off switch
Min/max capacity. 0,5/1,5 l
Temperature adjustment to 40°C, 50°C, 60°C, 70°C, 80°C, 90°C, 100°C
Covered heater
Illuminated interior: up to 50°C - turquoise, 50 to 60°C - green, 60 to 70°C - blue, 80-90°C
- yellow, 90-100°C - red
BEFORE USE
1. Place the kettle on flat, stable and dry surface.
2. Before first use, fill the kettle to the maximum, boil the water, pour it out and rinse the kettle.
Repeat this several times in order to remove factory deposits, etc.
3. The kettle will turn off automatically when the water boils. Each of the processes can be deacti-
vated if necessary with a switch
4. After boiling the water or turning off the kettle, wait a few seconds before turning it on again.
5. If the kettle is switched on without water, the overheating protection system will switch it off.
Allow the kettle to cool for about 15 minutes before refilling.
USING THE KETTLE
1. Before the first use, boil two full volumes of water in the kettle. Dispose of both volumes.
2. Remove the kettle from the power base (7) before filling with water.
3. Press the lid opening button (3) to open the lid and fill the kettle up to the desired level (no less
than 0.5 l and no more than 1.0 l). Close the lid carefully (2). Put the kettle on the power base (7).
Turn on the kettle with the On/Off switch (5).
boiling and heating water - use button (5b) to set the desired temperature (40°C, 50°C, 60°C, 70°C,
80°C, 90°C, 100°C) and start boiling or heating process with the switch (5a). When the water starts
boiling or reaches the set temperature, the kettle switches off automatically. However, if necessary, it
can be switched off earlier with the switch (5a)
b. touch button for changing the
temperature range
c. LED display
6.
Water level indicator with scale
7.
360º rotable kettle base
8.
Filter
9.
Temperature sensor
(5a).
EN
29
Publicidad
