Brother VX-1435 Manual De Operación página 11

THREADING THE MACHINE
Winding the bobbin
This section describes how to wind the thread onto the bobbin.
1 Pulling it in as
far as possible.
CAUTION
● Only use bobbins (part code: SA156, SFB: XA5539-151) that have been designed for this sewing
machine. Using other bobbins may cause damage to the machine.
● We designed the bobbin that comes with this machine. If you use bobbins from other models, the
machine will not work properly. Only use the bobbin that comes with this machine or bobbins of the
same type (part code: SA156, SFB: XA5539-151).
a Pull up the spool pin as far as possible, and
then put a spool of thread on this pin.
b Pass the thread around the pre-tension disk.
CAUTION
● If the spool of thread is not in the right place,
the thread may tangle on the spool pin.
c
Pass the end of the thread through the hole on
the bobbin from the inside of the bobbin.
d Put the bobbin onto the bobbin winder shaft and
slide the bobbin winder shaft to the right. Turn
the bobbin clockwise, by hand, until the spring
on the shaft slides into the groove of the bobbin.
a Spring on the shaft
b Groove of the bobbin
a Pre-tension disk
b Bobbin winder shaft
c Bobbin
Actual size
11.5 mm
(7/16 inches)
This model Other models
e Turn on the sewing machine.
f While holding the end of the thread, gently
press the foot controller to wind the thread
around the bobbin a few times. Then stop the
machine.
1
10