Publicidad
Ø Before Using Your Appliance
·
Remove the exterior and interior packing.
·
Check to be sure you have all of the following parts:
1
Instruction Manual
·
Before connecting the appliance to the power source, let it stand upright for approximately 2
hours. This will reduce the possibility of a malfunction in the cooling system from handling
during transportation.
·
Clean the interior surface with lukewarm water using a soft cloth.
Ø Installation of Your Freezer
·
Place your freezer on a floor that is strong enough to support the freezer when it is fully loaded.
To level your freezer, adjust the legs at the front of the freezer.
·
Allow 5 inches of space between the back and sides of the freezer, which allows the
proper air circulation to cool the compressor.
·
Locate the freezer away from direct sunlight and sources of heat (stove, heater, radiator, etc.).
Direct sunlight may affect the acrylic coating and heat sources may increase electrical
consumption. Extreme cold ambient temperatures may also cause the freezer not to perform
properly.
·
Avoid locating the freezer in moist areas. Too much moisture in the air will cause frost to form
quickly on the evaporator requiring more frequent defrosting of the freezer.
·
Plug the freezer into an exclusive properly installed-grounded wall outlet. Do not under any
circumstances cut or remove the third (ground) prong from the power cord. Any questions
concerning power and or grounding should be directed toward a certified electrician or an
authorized Avanti Products service center.
DO NOT INSTALL THE UNIT IN A LOCATION WHERE THE AMBIENT TEMPERATURE
WILL DROP BELOW 32 ºF OR RISE ABOVE 110 ºF. AMBIENT TEMPERATURES
OUTSIDE OF THIS RANGE WILL AFFECT THE PERFORMANCE OF YOUR UNIT AND
WILL NOT ALLOW TO MAINTAIN THE PROPER TEMPERATURES.
INSTALLATION INSTRUCTIONS
1
Plastic Spatula
8
Publicidad
