Important Safety Instructions; Installation Instructions; Before Using Your Appliance; Installation Of Your Appliance - Avanti CFC43Q0WG Manual De Instrucciones

WARNING
•
Read all instructions before using the freezer.
•
DANGER or WARNING: Risk of child entrapment.
Child entrapment and suffocation are not problems of the past. Junked or
abandoned appliances are still dangerous, even if they will "just sit in the garage a few days."
•
Before you throw away your old freezer: Take off the doors. Leave the shelves in place so
that children may not easily climb inside.
•
Never allow children to operate, play with, or crawl inside the appliance.
•
Never clean appliance parts with flammable fluids. The fumes can create a fire hazard or
explosion.
•
Do not store or use gasoline or any other flammable vapors and liquids in the vicinity of this or
any other appliance. The fumes can create a fire hazard or explosion.
Before Using Your Freezer
·
Remove the exterior and interior packing.
·
Check to be sure you have all of the following parts:
1 Storage Basket – Model CFC43Q0WG ONLY
2 Storage Baskets – Model CFC83Q0WG ONLY
2 Keys
·
Before connecting the freezer to the power source, let it stand upright for approximately 2 hours.
This will reduce the possibility of a malfunction in the cooling system from handling during
transportation.
·
Clean the interior surface with lukewarm water using a soft cloth.
Installation of Your Freezer
·
This appliance is designed to be free standing only, and should not be recessed or built-in.
·
Place your appliance on a floor that is strong enough to support the appliance when it is fully
loaded.
·
Allow 5 inches of space between the back and sides of the appliance, which allows the proper air
circulation to cool the compressor and condenser.
·
Locate the freezer away from direct sunlight and sources of heat (stove, heater, radiator, etc.).
Direct sunlight may affect the acrylic coating and heat sources may increase electrical consumption.
Extreme cold ambient temperatures may also cause the freezer not to perform properly.
·
Avoid locating the appliance in moist areas. Too much moisture in the air will cause frost to form
quickly on the evaporator requiring more frequent defrosting of the freezer.
·
Plug the appliance into an exclusive properly installed grounded wall outlet. Do not under any
circumstances cut or remove the third (ground) prong from the power cord. Any questions
concerning power and or grounding should be directed toward a certified electrician or an authorized
Avanti Products service center.
·
After plugging the appliance into a wall outlet, allow the unit to cool down for 2~3 hours before
placing food in the freezer compartment.
DO NOT INSTALL THE UNIT IN A LOCATION WHERE THE AMBIENT TEMPERATURE WILL DROP
BELOW 32 ºF OR RISE ABOVE 110 ºF. AMBIENT TEMPERATURES OUTSIDE OF THIS RANGE
WILL AFFECT THE PERFORMANCE OF YOUR UNIT AND WILL NOT ALLOW IT TO MAINTAIN THE
PROPER TEMPERATURES.

IMPORTANT SAFETY INSTRUCTIONS

To reduce the risk of fire, electrical shock, or injury when using
your freezer, follow these basic precautions:
-Save these instructions-

INSTALLATION INSTRUCTIONS

1 – Instruction Manual
1 – Plastic Scraper
4 - Rollers
7