Cub Cadet FT24 Manual De Operación página 7

Assembly & Set-Up
Contents of Carton
• One Tiller
• Four Tine Assemblies
• One Operator's Manual
Assembly
References to the right and left side of tiller are determined from
behind the equipment in the operating position.
Recommended Tools for Assembly
• 1⁄2" wrench
• Clean oil funnel
• Motor oil. Refer to the Engine Operator's Manual for oil
specifications and quantity required.
Tines
The tines must be installed correctly to insure proper operation.
See below for the proper tine installation:
1. The tines must be installed in the correct location and the
correct order. Each tine is marked as follows:
• A1 — Inner LH Tine
• A2 — Outer LH Tine
• B1 — Inner RH Tine
• B2 — Outer RH Tine
2. Using four clevis pins and four cotter pins from the manual
bag, install the tines onto the tine shaft inner tines first,
then the outer tines and exactly as shown in Figure 3-1.
B1
B2
B2
B1
Figure 3-1
NOTE: The outer tines can be placed in either of the two
outside holes. The inner hole is for a 22" tilling width and
the outer hole is for a 24" tilling width.
• One Handlebar Assembly
• One Wheel Assembly
• One Engine Operator's Manual
A2
A1
A1 A2
• One Depth Stake Assembly
• One Bottle of Oil
Wheel Assembly & Depth Stake Assembly
1. Remove the remaining clevis pin and cotter pin from the
manual bag, install the wheel assembly into the chain case
bracket as shown in Figure 3-2.
Figure 3-2
2. Remove the two screws from the bracket in the chain case.
See Figure 3-3.
Figure 3-3
3
7