Cub Cadet FT24 Manual De Operación página 9

Adjustments
Wheels
The tiller is shipped with the wheels adjusted so that the
machine sits level. The wheels need to be adjusted to meet
your tilling needs before operation. This adjustment is made by
removing the clevis pin from the chain case bracket and raising
the wheels to the desired height. See Figure 3-7.
Figure 3-7
Depth Stake
The depth stake can also be adjusted to set to control the tilling
depth. To raise or lower the depth stake, remove the clevis pin
and cotter pin place the depth stake in the desired position and
reinstall the hardware. See Figure 3-7.
NOTE: See the Operation section for more information.
Clutch Cable Adjustment
Before operating the tiller the adjustment of the forward clutch
cables must be checked.
1. Disconnect and ground the spark plug wire against the
engine.
2. Adjust the forward clutch cable by loosening the hex nut.
See Figure 3-8.
Cable Collar
Figure 3-8
3. Turn the cable collar section one or two turns to increase or
decrease tension on the cable. See Figure 3-8.
4. Retighten the lock nut against the cable collar. See Figure 3-8.
5. With the forward engagement handle in the neutral (released)
position, pull the starter rope several times. The tines should
not turn.
6. If they turn adjust the forward clutch cable to release
tension using the previous steps in this section.
7. Check again for correct tension on the cable.
8. After tilling, if the tines stop moving, re-adjust the cables.
Set-Up
Gas & Oil Fill-Up
Service the Engine with gasoline and oil as instructed in the
separate Engine Operator's Manual packed with your tiller. Read
the instructions carefully.
WARNING!
Use extreme care when handling
gasoline. Gasoline is extremely flammable and the
vapors are explosive. Never fuel the machine
indoors or while the engine is hot or running.
S
ection
Hex Nut
3 — A & S -U
SSembly et p
9