Publicidad
Idiomas disponibles
Idiomas disponibles
Function
Engraving
Polishing, rust removal
CAUTION! Exert only
a light pressure when
applying the tool to the
workpiece.
Cleaning
Grinding
Cutting
■
Note that the maximum diameter of the grinding
assembly and of grinding cones, pencil grinders
and grinding points with a thread insert may not
exceed 55 mm and the maximum diameter for
sandpaper sanding accessories may not exceed
80 mm.
NOTE
►
The max. permissible length of a mandrel is
33 mm.
■
Store the accessories in the original box or store
the accessory components somewhere else to
protect them from damage.
■
Store the accessories somewhere dry and not
in the vicinity of aggressive media.
■
If you exert too much pressure, the fitted tool can
break and/or the workpiece could be damaged.
You will achieve optimum working results by
moving the tool over the workpiece at a steady
speed and while exerting light pressure.
■
When carrying out cutting work, hold the appli-
ance firmly with both hands.
■
Observe the data and the information in the
table to prevent the end of the spindle from
touching the perforated base of the grinding tool.
PFBS 160 C3
Accessories
Engraving bits
Metal brush
Polishing
attachments
Synthetic brushes
Grinding discs
Grinding bits
Abrasive belts
Cutting discs
Use
Labelling, handicrafts
rust removal
Various metals and plastics, espe-
cially precious metals such as gold
and silver
e.g. cleaning hard-to-access
plastic housings or the area
around a door lock
Grinding work on stone, wood,
fine work on hard materials such
as ceramics or alloyed steel
Working metal, plastic and wood
Flexible shaft
■
Never operate the spindle lock while the motor
is running. Otherwise the appliance or the
flexible shaft could be damaged.
♦
Unscrew the union nut
appliance and store it carefully.
♦
Press the spindle lock
♦
Screw the tensioning nut
the appliance.
♦
The shaft needs to be pulled out a short distance
as it cannot be fixed into the collet chuck
otherwise.
♦
Fit the flexible shaft
To do this, the internal access of the flexible
shaft push the tensioning nut
chuck
.
♦
Press the spindle lock
♦
Now, tighten the tensioning nut
combination spanner
Now, screw the union nut
shaft
clockwise onto the appliance.
♦
Place the desired accessory into the collet
chuck
,
Protrusion
(min–max) mm
18–25
9–15
12–18
9–15
12–18
10
10
12–18
anticlockwise off the
and hold it down.
anticlockwise off
onto the appliance.
into the collet
and hold it down.
using the
.
of the flexible
14b
of the flexible shaft.
GB │ IE
│
11
■
Publicidad
