Aqua Medic heat controller duo II Manual De Instrucciones página 5

Idiomas disponibles

Digital temperature monitor and controller for aquarium and under gravel heater

With the purchase of this digital measuring and regulating unit, you have selected a top quality product. It has

been specifically designed for aquaristic purposes.

With this unit, you can continuously measure and control the water temperature of your aquarium and ensure a

flow of the under gravel.

1. Included in shipment

The Aqua Medic heat controller duo II is generally delivered with a water-resistant temperature sensor. The unit

is ready for connection. The units to be controlled (heaters, heating cables or mats) are connected to the double

socket.

2. Description

At socket No. 1, an aquarium heater can be controlled. Socket No. 2 is provided for controlling heating cables or

mats by a timer. The maximum output is approx. 1,200 watts.

3. Installation

Connect to 220 V power source.

- Place the temperature sensor into the aquarium and fix it with an Aqua Medic electrode holder. After a few

minutes, the actual aquarium water temperature is indicated.

Pict. 1: heat controller duo II

1. Socket No. 1 – heater

2. Socket No. 2 – heating cable

3. Operation symbol "heating"

4. Arrow keys to adjust the parameter

5. Display and timer heating cable ON – OFF

4. Adjustion

To program the controller, press the "SET" button. The stored setpoint starts to flash and can be adjusted with

the arrow keys. If no key is pressed for a few seconds, the display switches back to measuring mode.

If you hold down the respective arrow key for a few seconds, the display starts to run faster.

After tapping the SET button again, the display goes to the setting for the control accuracy and saves the

previously entered value. Use the arrow keys to set the desired value in 1 °C steps. If you press the SET button

again, the unit goes to the alarm value.

If the setpoint plus alarm value is exceeded, a beep sounds as an alarm signal during operation. This value is

also set with the arrow keys. The entered values are saved as soon as no button is pressed for a few seconds.

Operation Manual ENG