Publicidad
Idiomas disponibles
Idiomas disponibles
Installation requirements
Location requirements
Clearances and dimensions
BEFORE YOU BEGIN to install this appliance, refer to the following information,
dimensions, and clearances. Do not locate the range where it may be subject
to strong drafts. Provide adequate clearances between the range and adjacent
combustible surfaces. These dimensions must be met for safe use of the range.
The location of the electrical outlet and gas piping may be adjusted to meet the
following dimensions and clearances.
For installation in Canada, a free-standing range is not to be installed closer than
4.7 in (12 cm) from any adjacent surface.
CAUTION
This range has been designed to comply with the maximum allowable wood
cabinet temperature of 194 °F (90 °C). Make sure the wall covering, countertops,
and cabinets around the range can withstand the heat (up to 194 °F [90 °C])
generated by the range. If not, discoloration, delamination, or melting may occur.
Minimum from
top of cooktop to
cabinets
Side
30 in
Clearance
(76.2 cm)
Above
Cooking
4 in
30 in
Surface to
(10.2 cm)
(76.2 cm)
Wall
24 in
(61 cm)
36 in
Lower
(91.4 cm)
Cabinet
Depth
Install_NX60T9700_BEST_BETTER_AA_DG68-01243A-00_EN.indd 13
13 in (33 cm)
Overhead
Cabinet Depth
6 in
18 in
(15.2 cm)
(45.7 cm)
0 in (0 cm)
Clearance
24.2 in
Below
(61.5 cm)
Cooking Top
and at Rear
and Sides of
Range
CAUTION
Do not grasp the knob, handle and push when you install.
CAUTION
DO NOT install the oven so that the door is flush with the cabinet.
For OTR over Gas Stove, please follow local GAS CODE.
0 in
(0 cm)
English 13
2020-03-26
6:41:22
Publicidad
