Publicidad
Idiomas disponibles
Idiomas disponibles
appliance is also clearly indicated on
the rating plate located inside the
appliance, on the left wall down.
R600a is a non-polluting gas that does
not harm the ozone layer and whose
contribution to the greenhouse effect
is virtually zero.
Installation
WARNING: Correct
installation of your device complying
with the rules that are given in this
installation guide and use will allow
you to keep your food in good
conditions and with optimized energy
consumption.
If your appliance has wheels,
·
remember that they are only used to
facilitate small movements. Do not
move on longer distance.
Make an initial cleaning before
·
connecting your device to the mains.
Before any maintenance, disconnect
your device. Do not pull the power
cord but directly enter the profile.
Place the unit in a dry and ventilated
·
room.
Avoid balconies, porches, decks;
·
excessive heat in summer and cold in
winter could prevent proper operation
of your device, or even damage.
Do not place it near a heat source
·
such as radiator or oven for example.
Keep a minimum distance between
·
your refrigerator and other furniture:
3 to 5 cm on the sides and 10 cm
above for good air circulation around
the unit.
Place the appliance at a suitable
·
distance from the wall using the
spacers if they provided in the
accessory bag.
Your appliance has been designed
·
for optimum performance in a room
temperature. We then say that it is
designed for a special "climate class".
This climate class is clearly stated on
the rating plate located inside your
appliance, on the left wall down.
Beyond these temperatures, the
performance of your appliance may be
reduced.
Classe
Temperature
SN
from + 10°C to + 32°C
N
from + 16°C to + 32°C
ST
from + 16°C to + 38°C
T
from + 16°C to + 43°C
Advice:
After installation of your appliance, set
its feet so that it is slightly tilted
backwards, it will facilitate the closing
of the door.
Before putting food, clean the interior
and exterior of your appliance with
bicarbonate of soda dissolved in water
(1 tablespoon of bicarbonate for 4
litres of water). Do not use alcohol,
abrasive powders or detergents which
could damage the surfaces. (See
chapter "Cleaning your appliance").
ELECTRICAL CONNECTION
The electrical installation must comply
with the applicable standards and must
be able to withstand the maximum
power indicated on the rating plate.
The plug must be properly grounded.
We cannot be held responsible for any
incident caused by defective electrical
installation.
Electrical Installation Tips
• Do not use extension cable or
adapter or power strip.
• Never remove the grounding.
• The socket must be easily accessible
but out of reach of children.
In case of doubt, ask to your installer.
Your device is compliant with EU
directives and their modifications.
6
Publicidad
